Front Left Brake Caliper for 1989-1995 Toyota Pickup - CARDONE Reman 19-B1247

Be the first to review this product
$62.99
MPN: 19-B1247
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

CARDONE Reman Disc Brake Caliper P/N:19-B1247
CARDONE Reman Disc Brake Caliper P/N:19-B1247
$62.99

Clamp the brake pads against the rotor with the A1 CARDONE caliper 19-B1247, a remanufactured front left disc brake caliper that drops in as a direct-fit replacement for the 1989-1995 Toyota Pickup. Each unit is remanufactured to rigorous quality and performance standards, fitted with brand-new premium components, and 100% pressure-tested. This is an unloaded caliper — it ships without brake pads — and includes the mounting bracket, matching the "w/Bracket" configuration.

  • Durable pistons: resistant to cracking or pitting and built to handle great loads.
  • New high-temperature EPDM seals: the rubber seals are replaced for extended life and consistent performance.
  • Complete hardware: arrives with brand-new hardware — including banjo bolts, bleeder screws, washers, and stainless steel hardware clips and mounting pins where applicable — for a straightforward installation.
  • Pressure-tested & protected: 100% pressure-tested, treated with a special rust inhibitor, and kept in the original equipment finish.

A plastic cap plug protects each brake port thread during shipping. If a seized, leaking, or sticking caliper is the cause of your uneven braking or drag on the 1989-1995 Toyota Pickup, this A1 CARDONE brake caliper replaces it. For balanced braking, it is good practice to service calipers in axle pairs.

Interchange: 4775035050

This part cross-references / interchanges with the following part numbers:

4775035050

Frequently Asked Questions

What vehicle does this A1 CARDONE caliper fit?

It is a direct-fit replacement for the 1989-1995 Toyota Pickup. Check the Buyer's Guide tab to confirm the exact match for your vehicle.

Is this a loaded or unloaded brake caliper?

It is an unloaded caliper, so it ships without brake pads. The mounting bracket is included, matching the w/Bracket configuration.

Is the mounting bracket included?

Yes. This unit is supplied with its caliper bracket, along with brand-new hardware such as banjo bolts, bleeder screws, and clips where applicable.

Is the caliper tested before shipping?

Yes. Every CARDONE caliper is 100% pressure-tested, and the rubber seals are replaced with new high-temperature EPDM rubber.

Should I replace both calipers at once?

It is not required, but servicing calipers in axle pairs is good practice for even, balanced braking. This listing is for one caliper.