Rear Left Brake Caliper for 1998-2002 Mazda 626 - CARDONE Reman 19-B1597A

Be the first to review this product
$83.99
MPN: 19-B1597A
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

CARDONE Reman Disc Brake Caliper P/N:19-B1597A
CARDONE Reman Disc Brake Caliper P/N:19-B1597A
$83.99

Keep firm, even hydraulic braking on your Mazda with the A1 CARDONE caliper — the Reman Disc Brake Caliper 19-B1597A, a direct-fit replacement for the rear left position on the 1998-2002 Mazda 626. A brake caliper houses the piston that presses the brake pads against the rotor under hydraulic pressure. Each unit is expertly remanufactured to strict quality standards, fitted with brand-new premium components, and 100% pressure-tested for consistent braking.

This is an unloaded caliper (brake pads are not included) and it ships with the mounting bracket, matching its "w/Bracket" configuration.

  • New high-temperature EPDM seals: the rubber seals are replaced with new high-temperature EPDM rubber for extended life.
  • Durable pistons: resistant to cracking or pitting and built to handle heavy loads.
  • Rust inhibitor + OE finish: treated with a specially formulated rust inhibitor and kept in the original equipment finish.
  • Installation hardware: a new bleeder screw, stainless steel hardware clips, mounting pins, banjo bolts and washers are included where applicable, plus a plastic cap plug that protects the brake port threads.

Built through CARDONE's earth-friendly remanufacturing process, this A1 CARDONE brake caliper is a direct-fit replacement for the listed application. For balanced braking, plan on servicing the caliper on both sides of the axle together.

Interchange: GA2E2671XE · GDZE2699ZB

This part cross-references / interchanges with the following part numbers:

GA2E2671XE, GDZE2699ZB

Frequently Asked Questions

Does this A1 CARDONE brake caliper fit my 1998-2002 Mazda 626?

It is listed as a direct-fit replacement for the 1998-2002 Mazda 626. Check the Buyer's Guide tab to confirm the exact match for your vehicle.

Is this a loaded or unloaded caliper?

It is an unloaded caliper, so brake pads are not included. Reuse serviceable pads or install a new pad set as directed by the service procedure.

Does it come with a mounting bracket?

Yes. This unit ships with the caliper bracket, matching its "w/Bracket" configuration for a straightforward installation.

What installation hardware is included?

A new bleeder screw plus stainless steel hardware clips, mounting pins, banjo bolts and washers are included where applicable, and a plastic cap plug protects the brake port threads.

What are signs my brake caliper may need replacing?

Common signs include brake fluid leaking at the caliper, a sticking or dragging caliper, uneven pad wear, or the vehicle pulling to one side. Diagnose the cause before replacing.