Replace a leaking or sticking rear brake caliper with the A1 CARDONE Reman Brake Caliper 19-B2570, a remanufactured unloaded caliper supplied with its mounting bracket for the rear right position. It fits many vehicles, among them the 2000 Volkswagen Jetta, 1999 Volkswagen Golf and 2000 Audi TT. See the "Vehicles it fits" section for the full list and engine details.
Every A1 CARDONE caliper is remanufactured to strict quality and performance standards and fitted with new components. Each one is then 100% pressure-tested, which is designed to help deliver consistent braking. This disc brake caliper is sold unloaded, so brake pads are not included.
- Bracket included: Supplied as a caliper with its mounting bracket for a straightforward installation.
- Pistons and seals: The pistons are durable, resist cracking and pitting, and are made to handle heavy loads. The original rubber seals are replaced with new high-temperature EPDM rubber.
- Finish: Treated with a specially formulated rust inhibitor and kept in the original equipment finish.
- New hardware: A new bleeder screw allows easy bleeding and a positive seal. New banjo bolts, washers, stainless steel hardware clips and mounting pins are included where applicable. A plastic cap plug protects the brake port threads.
This unit is remanufactured from an original equipment part and is designed to match the factory fit. CARDONE's remanufacturing process uses 80% less energy and raw material than building a new part.
Interchange: 1J0615424 · 8N0615424
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
Is this the right 2000 VW Jetta brake caliper?
It is listed for the rear right position on the 2000 Volkswagen Jetta. It also fits the 1999 Volkswagen Golf and 2000 Audi TT. Check the "Vehicles it fits" section to confirm your exact vehicle.
Does this caliper come with brake pads?
No. It is an unloaded caliper, so brake pads are not included. It does come with its mounting bracket and a new bleeder screw.
What is renewed during remanufacturing?
The rubber seals are replaced with new high-temperature EPDM rubber and a new bleeder screw is fitted. The caliper is also treated with a rust inhibitor and 100% pressure-tested.
What are signs a brake caliper may need replacing?
Common signs are brake fluid leaking at the caliper, pulling to one side, a dragging brake or uneven pad wear. Other brake parts can cause similar symptoms, so diagnose the cause before replacing.
What should I do after installing it?
Bleed the brake system through the new bleeder screw. Follow the vehicle service information for torque specs and for whether the original fasteners may be reused.
Reviews
No reviews yet — be the first to review this product.
Write a ReviewWrite a Review