Replace a worn or leaking rear left caliper with the A1 CARDONE Remanufactured Brake Caliper 19-B2575, a 100% pressure-tested unit that arrives unloaded and comes with its mounting bracket. It fits many vehicles, among them the 2000-2005 Volkswagen Jetta, 2007-2009 Volkswagen Jetta City and 2008-2009 Volkswagen Jetta 2005-00. See the Buyer's Guide tab for the full list and engine details.
This disc brake caliper uses hydraulic pressure from the brake system to press the pads against the rotor. CARDONE remanufactures it to demanding quality and performance standards using brand-new premium components. As a remanufactured Original Equipment part, it is designed to fit like the original. It is treated with a specially formulated rust inhibitor and keeps the original equipment finish.
- New seals: the rubber seals are replaced with new high-temperature EPDM rubber.
- Durable pistons: resist cracking and pitting and handle heavy loads.
- New bleeder screws: provide trouble-free bleeding and a positive seal. A plastic cap plug protects every brake port thread.
- Hardware: new banjo bolts, washers, stainless steel hardware clips and mounting pins are included where applicable.
Because the caliper is unloaded, brake pads are not included. It is sold individually for the rear left position, and replacing both rear calipers together is recommended for even, balanced braking. CARDONE's remanufacturing process cuts the energy and raw material needed to make a new part by 80%.
Interchange: 1J0615423B · 8N0615423A
Frequently Asked Questions
Is this the right brake caliper for a 2000-2005 VW Jetta?
Does it fit the 2007-2009 Volkswagen Jetta City?
Yes. It is listed as a rear left caliper for the 2007-2009 Volkswagen Jetta City. The Buyer's Guide tab shows the remaining applications.
What comes in the box with this A1 CARDONE caliper?
You get the remanufactured caliper, its mounting bracket and new bleeder screws. New banjo bolts, washers, stainless steel clips and mounting pins are included where applicable. Brake pads are not included.
What are signs a brake caliper may need replacing?
Signs include brake fluid leaking at the caliper, a pull to one side, a dragging or sticking brake, and uneven pad wear. Diagnose the cause before you replace the caliper.
Does the brake system need bleeding after installation?
Yes. The brake hydraulic system must be bled after a caliper is replaced, and the new bleeder screws are designed for trouble-free bleeding. Follow the vehicle service information for the procedure.
