A1 CARDONE 19-B2627A rear left brake caliper for the 2004-2006 Nissan Sentra squeezes the brake pads against the rotor to slow the wheel. This remanufactured floating caliper, also called a disc brake caliper, has one steel piston.
- Remanufactured with brand-new components and 100% pressure-tested
- Steel piston that resists cracking and pitting and handles heavy loads
- Rubber seals replaced with new high-temperature EPDM rubber
- Treated with a specially formulated rust inhibitor and kept in the original finish
- New bleeder screw for trouble-free bleeding and a positive seal
Quick facts
- Part: A1 CARDONE 19-B2627A brake caliper
- Also called: disc brake caliper
- Fits: 2004-2006 Nissan Sentra
- Position: Rear left
- Material: Cast iron casting, steel piston
- Condition: Remanufactured
A car that pulls to one side when braking, or a pedal that sits low, can mean a caliper is worn. A collapsed brake hose or a binding slide pin can produce those signs as well. Rear calipers are normally replaced as a pair, and this listing is one caliper, for the rear left; the right side is ordered separately.
Fits
It fits the 2004-2006 Nissan Sentra, which takes one caliper on the rear left side.
Specifications
Fit and size
- Position: Rear left
- Quantity per application: 1
- Piston diameter: 33.909 mm (1.335 in)
- Inlet port: inverted flare, M10x1.0 thread, 10.00366 mm (0.394 in)
- Mounting hole diameter: 10.00366 mm (0.394 in)
- Mounting hole thread: M10x1.25
- Bleeder screw thread: M10x1.0
Build and materials
- Type: Floating, one piston
- Casting material: Cast iron
- Piston material: Steel
- Finish: Oil emulsion with a rust-resistant coating
- Condition: Remanufactured
- Country of origin: Mexico
In the box
One caliper with its bracket, a hardware kit and an instruction sheet. Brake pads, mounting bolts and a bleeder screw cap are not included, so plan on new mounting bolts.
Installation notes
- An instruction sheet comes with the caliper for the steps.
- A plastic cap plug covers each brake port thread.
- Use the brake fluid the vehicle's maker recommends; the type is stamped on the master cylinder reservoir lid, and the fluid should be new from a sealed container.
- Silicone grease is used on floating caliper mounting pins.
Interchange: 440116Z900
Frequently Asked Questions
Is this A1 CARDONE brake caliper the right one for the rear left of a 2004-2006 Nissan Sentra?
Yes. A1 CARDONE 19-B2627A is a rear left caliper for the 2004-2006 Nissan Sentra. The rear right side is a separate part.
Does the A1 CARDONE caliper come with a bracket and hardware?
Yes. A1 CARDONE 19-B2627A comes with its bracket, a hardware kit and an instruction sheet. Brake pads and mounting bolts are not included.
How big is the piston on this rear left caliper?
This caliper has one steel piston measuring 33.909 mm (1.335 in) across. It is a floating design.
What can cause brake squeal after a rear caliper like this one is installed?
Squeal can come from improperly installed brake pads, improperly installed brake hardware or an improper rotor finish. A shop can check which applies.
Which brake fluid goes in with this rear left caliper: DOT 3, DOT 4 or DOT 5?
Use the fluid the vehicle's maker recommends; the type is stamped on the master cylinder reservoir lid. Always use new fluid from a sealed container.
