A1 CARDONE 19-B2626A rear right brake caliper for the 2004-2006 Nissan Sentra clamps the pads against the rotor to slow the vehicle. Also called a disc brake caliper, this remanufactured unit is a floating design that comes without pads.
- Remanufactured with brand-new components and 100% pressure-tested
- Steel piston that resists cracking and pitting and handles heavy loads
- Rubber seals replaced with new high-temperature EPDM rubber
- Rust-inhibitor treatment on the caliper body
- New bleeder screw for trouble-free bleeding and a positive seal
Quick facts
- Part: A1 CARDONE 19-B2626A brake caliper
- Also called: disc brake caliper
- Fits: 2004-2006 Nissan Sentra
- Position: Rear right
- Material: Cast iron
- Condition: Remanufactured
Pulling to one side under braking, a low pedal or fluid around the caliper can mean this part is worn or leaking, though a collapsed brake hose or a binding slide pin can produce those signs too, so find the cause before you replace it.
Fits
This is a direct-fit replacement for the 2004-2006 Nissan Sentra. This listing is one caliper for the rear right; the rear left is a separate part, and both sides are normally replaced together. The 2004-2006 Nissan Sentra takes one for this side.
Specifications
Fit and size
- Position: Rear right
- Quantity per vehicle: 1 for this side
- Piston diameter: 33.909 mm (1.335 in)
- Inlet port: 10.00366 mm (0.394 in), M10x1.0 inverted flare
- Mounting hole: 10.00366 mm (0.394 in) diameter, M10x1.25 thread
- Bleeder screw thread: M10x1.0
Build and materials
- Type: Floating, unloaded (no pads)
- Piston: 1, steel
- Casting material: Cast iron
- Finish: Oil emulsion with a rust-resistant coating
- Condition: Remanufactured
- Country of origin: Mexico
In the box
One caliper with its bracket, a hardware kit and an instruction sheet. Pads are not included, and neither are the mounting bolts or the bleeder screw cap, so plan on new bolts.
Installation notes
- A plastic cap plug on every brake port protects the threads until installation.
- Use the brake fluid the vehicle manufacturer recommends, from a new sealed container.
- Silicone grease is used on floating caliper mounting pins.
Interchange: 440016Z900
Frequently Asked Questions
Is this A1 CARDONE brake caliper the right one for the 2004-2006 Nissan Sentra?
Yes. A1 CARDONE 19-B2626A is the rear right caliper for the 2004-2006 Nissan Sentra. The rear left caliper is a separate part.
Does the A1 CARDONE caliper come with pads or a bracket?
It comes with the bracket, a hardware kit and an instruction sheet, but no pads. The mounting bolts and the bleeder screw cap are not included.
Is the piston on this rear right caliper steel, and how big is it?
Yes, it has a single steel piston 33.909 mm (1.335 in) across in a floating caliper. A1 CARDONE 19-B2626A is unloaded, so the pads are bought separately.
What gets replaced when this brake caliper is remanufactured?
The rubber seals are replaced with new high-temperature EPDM rubber, and the caliper gets a new bleeder screw. Each unit is 100% pressure-tested.
What brake fluid should I use after changing a caliper?
Use the fluid the vehicle manufacturer recommends. The type is stamped on the master cylinder reservoir lid, and it should come from a new sealed container.
