Keep your Toyota Highlander brake caliper clamping the pads with consistent hydraulic force using the A1 CARDONE Remanufactured Unloaded Disc Brake Caliper (19-B2904), a direct-fit rear right replacement for the 2004-2007 Toyota Highlander. Each unit is expertly remanufactured with brand-new premium components and 100% pressure-tested for consistent brake performance.
This is an unloaded caliper, so brake pads are not included. A worn caliper can show brake fluid leaks, a sticking or dragging piston, uneven pad wear, or a pull to one side. If a failed caliper is the cause, this A1 CARDONE caliper replaces it.
Interchange: 4783048070
This part cross-references / interchanges with the following part numbers:
Does this A1 CARDONE brake caliper fit my 2004-2007 Toyota Highlander?
Yes. It is a direct-fit replacement for the 2004-2007 Toyota Highlander. Check the Buyer's Guide tab to confirm the match for your exact vehicle.
Is this an unloaded caliper, and are brake pads included?
It is an unloaded caliper, so brake pads are not included. Reuse your existing pads or install a new set separately.
What hardware comes with this A1 CARDONE caliper?
It ships with the caliper bracket and a complete set of new hardware. Banjo bolts, bleeder screws, washers, and stainless steel clips and mounting pins are included where applicable.
What are the signs my caliper may need replacing?
Watch for brake fluid leaks at the caliper, a sticking or dragging piston, uneven pad wear, or the vehicle pulling to one side. Diagnose the cause before replacing.
Should I replace calipers in pairs?
This caliper is sold individually; this listing is for one rear right caliper. Replacing both calipers on the same axle together as a matched pair is recommended for balanced braking.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
