CARDONE Reman Disc Brake Caliper P/N:19-B2604
Built to clamp the brake pads against the rotor at the front left wheel, the A1 CARDONE Remanufactured Brake Caliper 19-B2958 arrives unloaded with its mounting bracket, new seals and a new bleeder screw. It fits many vehicles, among them the 2007-2016 Honda CR-V, 2005-2010 Honda Odyssey and 2012-2015 Honda Crosstour; see the Buyer's Guide tab for the full list and engine details.
This unit is a remanufactured original equipment part. CARDONE rebuilds each caliper to strict quality and performance standards and fits it with new components.
Unloaded means brake pads are not included, so pair this caliper with pads suited to your vehicle. Signs a caliper may need replacing include brake fluid seeping at the caliper, a brake that drags or sticks, pulling to one side when braking, or uneven pad wear. Diagnose the cause before replacing any part. CARDONE's remanufacturing process uses 80% less energy and raw material than making a new part.
Interchange: 45019SHJA01 · 45019SHJA10 · 45019T0G000
This part cross-references / interchanges with the following part numbers:
Is this the right 2007-2016 Honda CR-V caliper for the front left wheel?
Yes. It is cataloged for the front left position on the 2007-2016 Honda CR-V, and it also fits the 2005-2010 Honda Odyssey and 2012-2015 Honda Crosstour. See the Buyer's Guide tab for engine details.
What does a disc brake caliper do?
Hydraulic brake fluid pressure pushes the caliper piston outward. This clamps the brake pads against the rotor to slow the wheel.
What comes in the box?
You get the remanufactured caliper with its mounting bracket, a new bleeder screw and a cap plug on the brake port. Banjo bolts, washers, clips and pins are included where applicable. Brake pads are not included.
What are signs the caliper may need replacing?
Common signs include brake fluid seeping at the caliper, a dragging or sticking brake, pulling to one side when braking, or uneven pad wear. Diagnose the cause before replacing parts.
Do I need to bleed the brakes after installing it?
Yes. Opening the hydraulic line lets air into the system, so bleed the brakes as described in the vehicle service information. The new bleeder screw is designed for easy bleeding and a positive seal.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.