CARDONE Reman Disc Brake Caliper P/N:19-B2604
Help keep braking consistent with the A1 CARDONE brake caliper 19-B3117, a remanufactured, unloaded disc brake caliper that ships with its mounting bracket. It fits many vehicles in the front right position, among them the 2005-2009 Ford Escape, 2007-2009 Mercury Mariner and 2008-2009 Mazda Tribute. See the Buyer's Guide tab for the full list.
CARDONE remanufactures this unit to its own quality and performance standards and fits it with new components. Each A1 CARDONE caliper is 100% pressure-tested. Because it is unloaded, brake pads are sold separately. As a remanufactured original equipment part, it is intended to match the original fit on the listed applications. If you are replacing a worn 2008 Ford Escape brake caliper on the front right, this unit replaces it.
New banjo bolts, washers, stainless steel hardware clips and mounting pins are included where applicable. CARDONE's remanufacturing process cuts the energy and raw material needed to make a new part by 80%.
Signs a caliper may need replacing include brake fluid leaking at the caliper, the vehicle pulling to one side under braking, a dragging brake or uneven pad wear. These symptoms can have other causes, so diagnose the problem before replacing parts.
Interchange: EFY53361XB · ZZC03361X
This part cross-references / interchanges with the following part numbers:
Is this the right caliper for a 2005-2009 Ford Escape?
It is listed for the front right position on the 2005-2009 Ford Escape. The Buyer's Guide tab shows every other listed vehicle.
Can it be used as a 2008-2009 Mazda Tribute brake caliper?
Yes. It fits the front right position on the 2008-2009 Mazda Tribute, and it also fits the 2007-2009 Mercury Mariner.
What does a brake caliper do?
It uses hydraulic pressure from the brake system to press the pads against the rotor. That creates the friction that slows the wheel.
What comes in the box?
You get the remanufactured caliper, its mounting bracket and new bleeder screws. Banjo bolts, washers, clips and pins are included where applicable. It is unloaded, so pads are sold separately.
What are signs a brake caliper may need replacing?
Fluid leaking at the caliper, pulling to one side when braking, a dragging brake or uneven pad wear may point to a caliper problem. Diagnose the cause before replacing.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.