A1 CARDONE 19-B3214 front right brake caliper for the 2006-2013 Suzuki Grand Vitara clamps the brake pads against the rotor to slow the wheel. This remanufactured A1 CARDONE caliper, also called a disc brake caliper, has a floating design and comes with its bracket.
- Rubber seals replaced with new high-temperature EPDM rubber
- Every caliper is 100% pressure-tested
- Single steel piston that resists cracking and pitting
- Rust-inhibitor treatment applied to the caliper body
- New bleeder screw for trouble-free bleeding and a positive seal
Quick facts
- Part: A1 CARDONE 19-B3214 brake caliper
- Also called: disc brake caliper
- Fits: 2006-2013 Suzuki Grand Vitara
- Position: Front right
- Material: Cast iron (caliper casting), steel (piston)
- Condition: Remanufactured
A car that pulls to one side under braking, or a pedal that sits low, can point to a sticking caliper. These signs alone do not prove the caliper is the problem; air in the brake system is another common cause. Replace the front calipers as a pair. This listing is one caliper for the front right, and the front left is ordered separately. Each side of the front axle takes one.
Fits
It is a direct-fit replacement brake caliper for the 2006-2013 Suzuki Grand Vitara, mounted on the front right side.
Specifications
Fit and size
- Position: Front right
- Quantity per vehicle: 1 per side of the axle
- Piston quantity: 1
- Piston diameter: 60.5282 mm (2.383 in)
- Mounting hole diameter: 11.98408 mm (0.472 in)
- Mounting hole thread: M12x1.25
- Inlet port: banjo fitting, M10x1.0 thread, 10.00366 mm (0.394 in)
- Bleeder thread: M8x1.0
Build and materials
- Caliper type: Floating
- Condition: Remanufactured
- Caliper casting material: Cast iron
- Piston material: Steel
- Finish: Oil emulsion, with rust-resistant coating
- Casting number: 18E
- Country of origin: Mexico
In the box
One brake caliper, its bracket, a hardware kit and an instruction sheet. Brake pads and the mounting bolt are not included, so plan on new mounting bolts.
Installation notes
- A plastic cap plug protects each brake port thread until installation.
- Silicone grease is used on floating caliper mounting pins.
- Use the brake fluid the vehicle maker recommends; the type is stamped on the master cylinder reservoir lid.
Interchange: 5510165J01999
Frequently Asked Questions
Does this front brake caliper fit the right side of the 2006-2013 Suzuki Grand Vitara?
Yes. A1 CARDONE 19-B3214 is the front right caliper for the 2006-2013 Suzuki Grand Vitara. The front left side is a separate part.
Does this A1 CARDONE brake caliper come with its bracket and hardware?
Yes. A1 CARDONE 19-B3214 ships with its bracket, a hardware kit and an instruction sheet. Brake pads and the mounting bolt are not included.
Is the piston in this caliper steel or phenolic?
Steel. This caliper has a single steel piston, 60.5282 mm (2.383 in) across.
My car pulls to one side when braking; could a sticking caliper be the reason?
Yes, a caliper with sticky slides or pins can do it. Have a shop inspect both calipers, the brake hoses and the steering and suspension, and don't keep driving with a braking problem.
Are the rubber seals on this remanufactured caliper new?
Yes. The rubber seals are replaced with new high-temperature EPDM rubber, and the bleeder screw is new. Each caliper is also pressure-tested.
