Get firm, even braking back on the road with the A1 CARDONE Remanufactured Disc Brake Caliper 19-B3412A, an unloaded rear right caliper supplied with its mounting bracket. It is a strong option if you are shopping for a caliper for a 2008-2010 Hyundai Sonata. It drops in as a direct-fit replacement for the 2008-2010 Hyundai Sonata (see the Buyer's Guide tab for engine-level details). As an unloaded unit it does not include brake pads, so order pads separately.
Each caliper is expertly remanufactured and 100% pressure-tested for consistent hydraulic performance.
CARDONE's remanufacturing process is earth-friendly, cutting the energy and raw material of a new part by roughly 80%. For balanced braking, service the calipers on the same axle together.
Interchange: 583113KA20
This part cross-references / interchanges with the following part numbers:
Does this caliper fit my 2008-2010 Hyundai Sonata?
Yes. This brake caliper is a direct-fit replacement for the 2008-2010 Hyundai Sonata. Check the Buyer's Guide tab to confirm your exact engine and configuration.
Is the mounting bracket included?
Yes. This is supplied as an unloaded caliper with its mounting bracket, so the bracket is included for installation on the listed applications.
Are brake pads included?
No. This is an unloaded caliper, meaning it ships without brake pads. Order the correct pads for your vehicle separately.
What hardware comes with the A1 CARDONE caliper?
Each unit arrives with brand-new hardware and a new bleeder screw for a positive seal, plus a plastic cap plug protecting the brake-port thread during install.
Should I replace both brake calipers at once?
It's a good practice to service the calipers on the same axle together for balanced, even braking. This listing covers one caliper.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
