CARDONE Reman Fuel Injection Throttle Body P/N:67-0002
A1 CARDONE 67-4007 fuel injection throttle body for the 2007-2014 Volkswagen Jetta 5-cylinder 2.5L and other vehicles controls the air that enters the engine. This remanufactured unit is taken apart and inspected, and each component is renewed or replaced.
A rough or unstable idle, hesitation when you press the pedal or a check engine light can mean a throttle body is worn or dirty. These signs alone do not prove the throttle body is the problem, since a vacuum leak can cause them too. If the throttle body is the cause, this unit replaces it.
The 2007-2014 Volkswagen Jetta 5-cylinder 2.5L, the 2012-2014 Volkswagen Passat 5-cylinder 2.5L and the 2010-2014 Volkswagen Golf 5-cylinder 2.5L all take this throttle body, and so do other vehicles.
Fit and size
Build and materials
One fuel injection throttle body with its throttle position sensor, and one instruction sheet. This listing is one throttle body, and each vehicle takes one. Mounting hardware, gaskets or seals, fuel injectors, an idle air control motor and a throttle body spacer are not included, so plan on new mounting hardware.
Interchange: 07K133062A
This part cross-references / interchanges with the following part numbers:
Does the A1 CARDONE 67-4007 fit a 2012-2014 Volkswagen Passat 5-cylinder 2.5L?
Yes, A1 CARDONE 67-4007 fits the 2012-2014 Volkswagen Passat 5-cylinder 2.5L. If your car is not named here, look it up in the "Vehicles it fits" section of this page.
Does this throttle body come with the throttle position sensor, or do I need gaskets?
Yes, the throttle position sensor is included, along with an instruction sheet. Gaskets or seals, mounting hardware, fuel injectors and an idle air control motor are not included.
What are the inlet and bore diameters of the A1 CARDONE 67-4007 throttle body?
A1 CARDONE 67-4007 has a 75 mm (2.956 in) inlet, a 65 mm (2.562 in) bore and a 67 mm (2.641 in) outlet.
Could an unstable idle mean my throttle body is going bad?
It can. An unstable idle, hesitation on acceleration or a warning light are common signs, and a shop can test the unit to confirm.
Are the throttle position sensors on this remanufactured unit tested?
Yes. The integrated high and low throttle position sensors are tested across their entire operational range, and the final assembly is checked for response time and air flow at multiple points.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.