Keep your front brake pads seated, sliding, and biting evenly with the Carlson Disc Brake Caliper Abutment Service Kit P653A. This front-axle hardware kit refreshes the abutment clips and hardware that locate the pads in the caliper bracket, and it installs as a direct-fit replacement on the 1996-1999 INFINITI I30 and 1995-1999 NISSAN MAXIMA — see the Buyer's Guide tab for engine-level fitment and the full application list.
Worn or corroded abutment hardware can let pads bind, rattle, or wear unevenly. Replacing this hardware whenever you service the front pads is good practice for even, quiet braking. If failed abutment hardware is the cause of your pad noise or uneven wear, this kit replaces it.
Interchange: FHP653A · 15254A
This part cross-references / interchanges with the following part numbers:
What is the Carlson P653A?
It is a front disc brake caliper abutment service kit — the clips and hardware that locate and retain the brake pads in the caliper bracket. Replacing it helps the pads move in a uniform, stable motion.
What vehicles does this kit fit?
It is a direct-fit replacement for the 1996-1999 INFINITI I30 and 1995-1999 NISSAN MAXIMA. Check the Buyer's Guide tab for engine-level details and the complete application list.
Is this a front or rear kit?
This is a front-axle abutment service kit, so it services the front brakes on the listed applications.
When should I replace this hardware?
Replace it whenever you service the front pads, or if worn or corroded hardware is causing pad noise, rattling, binding, or uneven pad wear. Fresh hardware helps restore quiet, even braking.
What numbers does this kit interchange with?
It interchanges with FHP653A and 15254A. Matching any of these to your original hardware helps confirm this is the correct replacement kit.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
