Keep your caliper sliding freely and your pads meeting the rotor squarely with the Carlson disc brake caliper pin kit 14090. Caliper guide pins let the caliper float over the brake pads, and when the friction material is worn enough to replace, the hardware that carries it is a smart thing to renew at the same time. This kit drops in as a direct-fit replacement for front and rear disc brake applications across a range of Acura, Honda and Isuzu models — including the 1990-2007 Honda Accord, 1997-2001 Honda CR-V and 1995-1998 Honda Odyssey. See the Buyer's Guide tab for the full list of covered years and makes.
If worn or seized guide pins are causing your caliper to bind, this kit replaces them.
Interchange: H15070 · FH14090 · H15085
This part cross-references / interchanges with the following part numbers:
What is the Carlson 14090 caliper pin kit?
It is a set of disc brake caliper guide pins that let the caliper slide over the pads so they contact the rotor at the correct angle for even braking.
Does this kit fit front or rear brakes?
The catalog lists this kit for both front and rear disc brake caliper applications on the covered vehicles.
Which vehicles does it fit?
It fits a range of Acura, Honda and Isuzu models, including the 1990-2007 Honda Accord, 1997-2001 Honda CR-V and 1995-1998 Honda Odyssey. Check the Buyer's Guide tab for the full list.
Why replace the caliper guide pins with the pads?
Brake service experts advise renewing the hardware when the friction material is replaced, since worn or seized guide pins can keep the caliper from sliding freely and cause uneven pad wear.
What numbers does part 14090 interchange with?
It cross-references H15070, FH14090 and H15085.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
