Keep your front brakes sliding smoothly with the Carlson disc brake caliper pin kit, MPN H5016. This front Disc Brake Caliper Guide Pin set drops in as a direct-fit replacement for many vehicles, among them the 1983-1993 Ford Mustang and 1983-1988 Ford Thunderbird — see the Buyer's Guide tab for engine specifics and the full list.
Brakes are engineered as a system — when the friction material is due, the hardware is too. Replacing worn or seized guide pins helps the caliper slide freely so the pads wear evenly. If sticking pins are behind uneven pad wear or noise on your vehicle, this kit replaces them.
Interchange: H5032 · FHH5016
This part cross-references / interchanges with the following part numbers:
What is the Carlson disc brake caliper pin kit H5016?
It's a front disc brake caliper guide pin kit. The pins hold the caliper piston in place and let the caliper slide so the pads meet the rotor at the correct angle for even braking.
Which vehicles does H5016 fit?
It's a direct-fit replacement for many vehicles, such as the 1983-1993 Ford Mustang and 1983-1988 Ford Thunderbird. See the Buyer's Guide tab for the full list.
Should I replace the guide pins when I do a brake job?
Brake experts agree that when the friction material is ready to be replaced, the hardware is too. Fresh guide pins help the caliper slide freely for even pad wear and quieter operation.
Are the pins corrosion resistant?
Yes. The pins have a corrosion-resistant coating to guard against rust from harsh road conditions.
What numbers does this kit interchange with?
It cross-references H5032 and FHH5016. Match your original hardware and confirm fitment for your vehicle before ordering.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
