Centric Parts Brake Hydraulic Hose P/N:150.66358
Keep pressurized brake fluid moving to the rear right wheel with the Centric Parts brake hydraulic hose, part number 150.65373. It is a direct-fit replacement for the listed applications on the 2002-2005 Ford Explorer, 2003-2005 Lincoln Aviator and 2002-2005 Mercury Mountaineer. The hose is the flexible link between the vehicle's rigid brake line and the brake at that wheel. It passes fluid pressure through while the suspension moves up and down.
Signs a brake hose may need replacing include brake fluid seeping at the hose or its fittings, a cracked, swollen or chafed hose, a soft or spongy pedal, or the vehicle pulling to one side under braking. Other parts can cause these symptoms, so inspect the brake system before replacing anything. If a failed rear right hose is the cause, this part replaces it. The brake system must be bled after installation. Consult the vehicle service information for the correct fasteners and any sealing hardware, and for whether the originals may be reused. See the "Vehicles it fits" section for engine-level fitment details.
Interchange: 79061 · 513348 · H620004 · E15570378 · 1L2Z2282AA · BH382474 · 2204565 · 224565 · BH140231 · F140231
This part cross-references / interchanges with the following part numbers:
What does this brake hydraulic hose do?
It is the flexible section of the brake line. It carries pressurized brake fluid from the rigid line to the brake at the rear right wheel and flexes as the suspension moves.
Which vehicles does this brake hose fit?
It is a direct-fit replacement for listed applications on the 2002-2005 Ford Explorer, 2003-2005 Lincoln Aviator and 2002-2005 Mercury Mountaineer. See the "Vehicles it fits" section for details.
Which wheel position is this hose for?
This hose is cataloged for the rear right position on the listed applications.
What signs suggest a brake hose may need replacing?
Fluid seeping at the hose or fittings, a cracked or swollen hose, a spongy pedal, or pulling under braking. Other parts can cause these symptoms, so inspect the system first.
Do I need to bleed the brakes after installing it?
Yes. Opening the hydraulic system lets air in, so the brakes must be bled after the new hose is installed. Follow the vehicle service information for the procedure and fastener requirements.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.