Cloyes Engine Timing Chain Tensioner P/N:9-6136
Cloyes 9-5747 right timing chain tensioner for the 2013-2022 Ram 1500 V6 3.6L and other vehicles keeps the timing chain under the right tension. It is a standard replacement for the right-side tensioner.
A worn tensioner can show up as a rattle near the timing chain or a timing-related warning light. Before you replace it, have a shop confirm the tensioner is the source, because a stretched chain or worn guides and sprockets can make a similar noise. During service, the chain, guides and sprockets are replaced along with the tensioners to keep the whole timing system sound. Left and right tensioners are normally done together; this listing is one right tensioner, and the left is a separate part.
The 2013-2022 Ram 1500 V6 3.6L, the 2011-2022 Jeep Grand Cherokee V6 3.6L and the 2012-2022 Jeep Wrangler V6 3.6L are among the vehicles it fits, at one tensioner per listing. If your vehicle isn't named here, look for it in the "Vehicles it fits" section.
Fit and size
Build and materials
One right timing chain tensioner. Mounting bolts, mounting hardware, a gasket or seal and a shoe are not included, so plan on new bolts rather than reusing the old ones.
Product information is for general reference and may contain errors. See our Disclaimer.
Is this the right Jeep Wrangler timing chain tensioner for the 2012-2022 V6 3.6L?
Yes. Cloyes 9-5747 is listed for the 2012-2022 Jeep Wrangler V6 3.6L as a right-side tensioner; the left side is a separate part.
Do I need new mounting bolts with this Cloyes right timing chain tensioner?
Yes, buy them separately. This tensioner comes without mounting bolts, hardware, a gasket or seal, or a shoe, and the old bolts should not be reused.
Is an engine timing chain tensioner spring or hydraulic?
Cloyes 9-5747 has a hydraulic and spring damper with an activation pin.
How can I tell if a right timing chain tensioner is going bad?
Signs can include a rattle near the timing chain or a timing-related warning light. A shop can inspect the tensioner and chain; this is not a check to run with the engine on.
What size are the mounting holes on the Cloyes 9-5747 tensioner?
This tensioner has two mounting holes, each 0.27 in (6.858 mm) in diameter.
Published by the manufacturer of this part. Links open in a new tab.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.