VALEO 835115 clutch flywheel conversion kit for the 2011-2013 BMW 128i 6-cylinder 3.0L and other vehicles replaces the dual mass flywheel (DMF) with a solid flywheel. A long travel damper in the clutch disc takes over the damping job.
- Valeo Conversion Kits product line, with a solid flywheel in place of the DMF
- F510 friction material, an organic compound with higher copper content for heat dissipation and protection from premature failure
- Specific friction plate with higher damper capacity to filter noise, vibration and harshness
- Solid flywheel plus increased clamp load from the clutch cover (pressure plate) for higher torque transfer efficiency
Quick facts
- Part: VALEO 835115 clutch flywheel conversion kit
- Fits: the 2011-2013 BMW 128i 6-cylinder 3.0L and other vehicles
- Condition: New
A worn clutch can show up as slipping under load, a pedal that grabs oddly or shudder when pulling away. Before you replace the clutch, rule out other sources of those signs, such as the clutch hydraulics, because the cause is not always inside the clutch.
Fits
This clutch flywheel conversion kit is a direct-fit replacement for the 2007-2013 BMW 328i 6-cylinder 3.0L and the 2012-2013 328i 4-cylinder 2.0L, and for the 2006-2011 BMW 323i 6-cylinder 2.5L. The 2006-2011 BMW 323i 6-cylinder 2.5L takes one kit. Open the "Vehicles it fits" section to check your exact model and engine.
Specifications
- Quantity per vehicle: 1
- Flywheel: solid
- Friction material: F510, organic compound with higher copper content
- Damper: long travel damper in the clutch disc
- Condition: New
- Warranty: Valeo 600,000 mile warranty on the single mass flywheel
- Country of origin: Spain
In the box
One clutch disc, one clutch cover (pressure plate), one flywheel and one release bearing.
Installation notes
- Bolt-on installation.
- No special tools or pre-loading required.
Interchange: 03-063 · 03-064
218736 · 21207553147 · 21207556558 · 21207567625 · 21207587368 · DMF082
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
218736, 21207553147, 21207556558, 21207567625, 21207587368, 03-063, 03-064, DMF082
Frequently Asked Questions
Will the VALEO 835115 kit fit a 2011-2013 BMW 128i 6-cylinder 3.0L?
Yes. VALEO 835115 is a direct-fit clutch flywheel conversion kit for the 2011-2013 BMW 128i 6-cylinder 3.0L, and that car takes one kit.
What is in the VALEO flywheel conversion kit?
VALEO 835115 contains a clutch disc, a clutch cover (pressure plate), a flywheel and a release bearing.
What friction material does this VALEO conversion kit use?
This kit uses Valeo's F510 friction material, an organic compound with higher copper content that helps dissipate heat.
Does this clutch flywheel conversion kit need special tools or pre-loading?
No. The kit is a bolt-on installation and needs no special tools or pre-loading.
What warranty covers the flywheel in this VALEO kit?
Valeo offers a 600,000 mile warranty on the single mass flywheel in VALEO 835115.
