MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK641505
$134.99
(You save)
Restore precise wheel location and quiet, controlled handling with the MOOG RK641505 Front Left Upper Suspension Control Arm and Ball Joint Assembly. This premium assembly drops in as a direct-fit replacement for the 2003-2020 Chevrolet Express 2500, 2003-2020 Chevrolet Express 3500, 2009-2019 Chevrolet Express 4500, 1999-2000 Chevrolet Silverado 2500, 2003-2019 GMC Savana 2500, 2003-2019 GMC Savana 3500, 2009-2018 GMC Savana 4500 and 1999-2000 GMC Sierra 2500 — see the Buyer's Guide tab for the full list. MOOG engineers these control arms for structural strength and corrosion protection.
Carbon fiber bearing: Induction-hardened studs add strength while a patent-pending carbon fiber-reinforced bearing reduces socket friction versus typical non-reinforced bearings for longer socket life.
Greaseable socket: Lets new lubricant flush out contaminants to reduce corrosion and wear, and a pre-installed dust boot seal helps keep dirt and water out.
Corrosion protection: Specially-engineered coatings on metal surfaces help inhibit deterioration from rain, snow, salt and road grime; premium pre-installed bushings are tuned to inhibit noise.
Ready to install: Includes all necessary hardware, precision tolerances for an accurate fit and alignment, and a laser-etched ID marking genuine MOOG quality.
It is the front left (driver-side) upper control arm and ball joint assembly, replacing the original unit in that position on the listed applications.
Does it come with the ball joint and bushings installed?
Yes. It ships as a complete assembly with the ball joint, pre-installed premium bushings, and a pre-installed dust boot seal, so there is no need to press in separate parts.
Is mounting hardware included?
Yes. MOOG includes all the necessary hardware for installation, and its precision tolerances are designed for an accurate fit and easier steering alignment.
Can the ball joint be greased?
Yes. It features a greaseable socket, which lets fresh lubricant flush out contaminants to help reduce corrosion and wear over time.
What are signs this control arm may need replacing?
Common signs include clunking or knocking over the suspension, loose or wandering steering, uneven tire wear, or a torn ball joint boot. Diagnose the cause before replacing.
Write a Review
MOOG
MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK641505
Tighten up rear suspension geometry and restore a solid ball-joint connection with the MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly RK622137. This premium MOOG assembly is a...
MOOG RK620334 Front Left Lower Suspension Control Arm and Ball Joint Assembly for Toyota CamryMOOG premium control arms for foreign and domestic nameplates are engineered for structural strength and...
MOOG RK620566 Front Right Lower Suspension Control Arm and Ball Joint Assembly for Nissan VersaFront Right Lower Suspension Control Arm and Ball Joint AssemblyMOOG premium control arms for foreign...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
