Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS20369
$46.99
(You save)
Tighten up loose, wandering steering with the Mevotech Supreme control arm, part number CMS20369 — a front left lower control arm and ball joint assembly that drops in as a direct-fit replacement for the 1996-2000 Chrysler Town & Country, 1996-2000 Dodge Caravan and Grand Caravan, 1996-2000 Chrysler Grand Voyager and Voyager, and 1996-2000 Plymouth Grand Voyager and Voyager. See the Buyer's Guide tab for the full engine breakdown.
Cast steel construction: built to OE-level tolerances for the front lower position.
Fasteners included: installs with an application-specific pinch bolt and locking nut so the integrated ball joint seats faster.
Simple to service: a 90-degree SAE grease fitting is included for easy lubrication.
Resists corrosion: a protective surface treatment helps limit rust build-up.
The arm locates the front wheel and pivots on its bushings, while the integrated ball joint lets the knuckle steer and travel. If a worn ball joint or tired bushings are behind clunking over bumps, loose steering, or uneven tire wear, replacing this assembly renews both in one part. Backed by extensive in-house and third-party durability testing.
Frequently Asked Questions
What vehicles does the Mevotech Supreme CMS20369 fit?
It fits the 1996-2000 Chrysler Town & Country, Dodge Caravan and Grand Caravan, Chrysler Grand Voyager and Voyager, and Plymouth Grand Voyager and Voyager. Check the Buyer's Guide tab for engine details.
Is this a lower control arm and which side?
Yes — CMS20369 is the front left (driver-side) lower control arm and ball joint assembly for these Chrysler, Dodge and Plymouth minivans.
Does this Dodge Caravan control arm include the ball joint and hardware?
Yes. The ball joint is integrated into the arm, and an application-specific pinch bolt and locking nut are included, along with a 90-degree SAE grease fitting for service.
What are signs my Caravan control arm may need replacing?
Clunking over bumps, loose or wandering steering, and uneven front tire wear can be signs the ball joint or bushings are worn. Diagnose the cause before replacing.
Do I need to replace both sides?
This listing covers the front left corner only; the right side is a separate part. If both sides show wear, replacing them together helps keep front-end handling balanced.
Write a Review
Mevotech Supreme
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS20369
Keep the front suspension tight and precise with the Mevotech Supreme control arm and ball joint assembly (P/N: CMS86142), a front right lower unit that drops in as a direct-fit replacement for the...
Steer with tight, predictable response using the Mevotech Supreme control arm and ball joint assembly (CMS40121), a front right upper unit that locates the suspension and carries an integrated ball...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
