DORMAN OE SOLUTIONS 526-654 front right lower control arm with ball joint for the 2010-2024 Toyota 4Runner and other vehicles supports the front right wheel as the suspension moves. Sold as a control arm and ball joint assembly, it directly replaces the original.
A worn arm, bushing or ball joint can show up as a clunk over bumps, loose steering or uneven tire wear. Before you replace this arm, rule out a worn tie rod or strut and tire problems, since these can also produce noises, pulling or uneven wear.
This control arm fits the 2010-2024 Toyota 4Runner and the 2010-2014 Toyota FJ Cruiser. This listing is one arm for the front right; the front left is a separate part, and the two sides of that axle are normally replaced together.
Fit and size
Build and materials
One control arm, one castle nut and one cotter pin; a grease fitting is not included. This listing holds one control arm, and the front right position takes one.
Interchange: 102-8345
TC8303 · CA7499 · 9CB86533 · RK623321 · GS861083 · CMS861083 · 2608771 · X50CJ0384 · 4806860040
This part cross-references / interchanges with the following part numbers:
Is this a lower control arm for the 2010-2024 Toyota 4Runner?
Yes. DORMAN OE SOLUTIONS 526-654 fits the 2010-2024 Toyota 4Runner in the front right lower position. The other side of that axle takes its own arm.
Is this a control arm for the 2010-2014 Toyota FJ Cruiser?
Yes. This front right lower arm fits the 2010-2014 Toyota FJ Cruiser, in the same front right lower position.
What size is the ball joint stud on this control arm?
DORMAN OE SOLUTIONS 526-654 has a threaded ball joint stud with a 16 mm thread diameter and a 21.8 mm stud length. The arm has four 16.2 mm mounting holes.
Can a worn front right lower control arm cause clunking over bumps?
A worn arm, bushing or ball joint can be one source of a clunk over bumps, loose steering or uneven tire wear on that side. A shop can inspect the front end to pin down the cause.
Does the DORMAN OE SOLUTIONS control arm come with the ball joint installed?
Yes. The ball joint and bushings are pre-installed and the ball joint is pre-greased. A castle nut and cotter pin are in the box; a grease fitting is not included.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
