Keep coolant moving through your heater circuit with the Dayco Heater Hose 88482, a molded HVAC heater hose that installs as a direct-fit replacement for the 2008-2011 Ford Focus [L4-2.0L] and the 2010 Toyota Camry [V6-3.5L]. This hose carries hot engine coolant between the engine and the heater core, and its molded shape holds the bends needed to route cleanly along its cataloged path.
A cracked, swollen, or leaking heater hose can allow coolant loss and reduced heat at the vents; if a failed hose is the cause, replacing it with this molded unit restores the intended coolant path. Made in Mexico.
Interchange: 18449L · 19883 · KH484 · 11883
This part cross-references / interchanges with the following part numbers:
Does this hose fit my vehicle?
It's cataloged for the 2008-2011 Ford Focus with the L4-2.0L engine and the 2010 Toyota Camry with the V6-3.5L. Check the Buyer's Guide tab to confirm your exact vehicle.
What is an HVAC heater hose?
It carries hot engine coolant between the engine and the heater core, supplying the heat the HVAC system uses to warm the cabin.
What size is this hose?
Both ends have a 0.75 in inside diameter, and the hose has a 24.5 in centerline length.
Why is it molded instead of straight?
The hose is molded to a preformed shape so it holds the bends needed to follow its cataloged routing without kinking.
What are signs this hose may need replacing?
Coolant leaks or drips near the hose, cracking or swelling, and reduced heat at the vents can be signs the hose may need to be replaced.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
