Delphi SS20794 sensor for the 2020-2026 Audi A6 Allroad and other vehicles is a front ABS wheel speed sensor, the part that reports wheel speed to the ABS.
- Each Delphi sensor is tested and calibrated to OE standards for accurate readings.
- Built to meet or exceed OE requirements and testing.
- Plated connectors help prevent corrosion and failure commonly caused by internal and cable short circuits.
- The OE design helps prevent mechanical damage to the sensor wheel, soiling and increased wheel bearing free play.
- Performance stays steady through drastic temperature changes.
- Digital output is designed for maximum signal to noise ratio.
A failing sensor can show up as an ABS warning light. Before you replace this sensor, rule out a damaged connector or cable and a damaged sensor wheel, since a fault in either one can set off the same warning.
The sensor is listed for a wide range of Audi models, including the 2019-2026 Audi A6 Quattro and the 2019-2026 Audi A8 Quattro. These cars take two, one on each side of the front axle. This listing is a single sensor, and the other side of the same axle is normally done at the same time.
Specifications
Fit and size
- Position: Front
- Quantity per vehicle: 2
- Sold as: 1 sensor per listing
Build and materials
- Output: digital
- Connectors: plated
- Country of origin: China
In the box: one ABS wheel speed sensor and an instruction sheet.
Interchange: 4M0 927 803 C
ABS3236 · 533607 · ALS3236 · 5S17266
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
4M0 927 803 C, ABS3236, 533607, ALS3236, 5S17266
Frequently Asked Questions
Is the Delphi SS20794 one of the Audi A6 Quattro sensors for a 2019-2026 model?
Yes. The Delphi SS20794 is a front sensor listed for the 2019-2026 Audi A6 Quattro and the 2019-2026 Audi A8 Quattro, among other Audi models. Check your own car in the "Vehicles it fits" section.
Does the Delphi SS20794 come with an instruction sheet?
Yes. The Delphi SS20794 ships with one ABS wheel speed sensor and an instruction sheet.
Are the connectors on this front sensor plated?
Yes. The connectors are plated to help prevent corrosion and failure commonly caused by internal and cable short circuits.
What can a failing front sensor look like?
A failing front sensor can show up as an ABS warning light or ABS that stops working. A shop can test the circuit to confirm the sensor is at fault.
Does the Delphi SS20794 replace interchange number 4M0 927 803 C?
Yes. 4M0 927 803 C is one of the interchange numbers listed for the Delphi SS20794, along with ABS3236, 533607, ALS3236 and 5S17266.
