Delphi SS20869 front ABS wheel speed sensor for the 2013-2018 Nissan Altima 4-cylinder 2.5L or V6 3.5L and other vehicles reports wheel speed to the ABS. Each sensor is tested and calibrated to OE standards for accurate readings.
- Plated connectors help prevent corrosion and failure from internal and cable short circuits
- Digital output designed for maximum signal to noise ratio
- Keeps its performance through drastic temperature changes
- Design helps prevent mechanical damage to the sensor wheel, soiling and increased wheel bearing free play
Quick facts
- Part: Delphi SS20869 ABS wheel speed sensor
- Fits: 2013-2018 Nissan Altima 4-cylinder 2.5L or V6 3.5L and other vehicles
- Position: Front
- Condition: New
A lit ABS warning light, or ABS and traction control that stop working, can mean a wheel speed sensor has failed. If this sensor is the cause, this one replaces it. During a brake or tire service, when the wheel is off, look over the sensor's connector and wiring for corrosion or cuts, since a poor connection can set off that light too.
Fits
This is a direct-fit replacement for the 2013-2018 Nissan Altima 4-cylinder 2.5L or V6 3.5L and the 2016-2023 Nissan Maxima.
Specifications
Fit and size
- Position: Front
- Quantity per vehicle: 2
Build and materials
- Connectors: plated
- Output: digital
- Condition: New
In the box
One ABS wheel speed sensor and one instruction sheet. This listing is a single sensor, and the front axle on these vehicles takes two.
Interchange: 47910-3TA0A · 47910-3TA1A · 47910-3TA2A
ABS2554 · 532924 · ALS2554 · 5S14121
This part cross-references / interchanges with the following part numbers:
ABS2554, 47910-3TA0A, 47910-3TA1A, 47910-3TA2A, 532924, ALS2554, 5S14121
Frequently Asked Questions
Does the Delphi SS20869 fit the 2013-2018 Nissan Altima 4-cylinder 2.5L or V6 3.5L?
Yes. Delphi SS20869 is a front ABS wheel speed sensor for the 2013-2018 Nissan Altima 4-cylinder 2.5L or V6 3.5L, and it also fits the 2016-2023 Nissan Maxima.
Does the Delphi SS20869 come with an instruction sheet?
Yes. Delphi SS20869 comes with one front ABS wheel speed sensor and an instruction sheet. The front axle takes two sensors, so this listing covers one of them.
Are the connectors on this Delphi ABS wheel speed sensor plated?
Yes. The connectors are plated to help prevent corrosion and failure commonly caused by internal and cable short circuits.
Which warning signs can point to a bad front ABS wheel speed sensor?
An ABS warning light, or ABS and traction control that stop working, can mean the sensor has failed. A shop can scan the system to find the actual cause.
Does this Delphi sensor hold up through temperature swings?
Yes. This sensor maintains its performance through drastic temperature changes, and its digital output is designed for maximum signal to noise ratio.
