Delphi FE0070 electric fuel pump for the 1987-1989 Ford F-150 6-cylinder 4.9L or V8 5.0L, the 1988-1989 F-150 V8 5.8L and other vehicles sits inside the fuel tank and pushes fuel to the engine. It is built to Delphi's OE standards.
- Designed to operate under extreme temperatures with quick engine starts
- Lower amperage draw, so less load on the vehicle's electrical system
- Designed to bring back fast pressure performance and system integrity while using less energy
- Validated and tested before it is matched to its vehicle application
Quick facts
- Part: Delphi FE0070 electric fuel pump
- Fits: 1987-1989 Ford F-150 6-cylinder 4.9L or V8 5.0L, the 1988-1989 F-150 V8 5.8L and other vehicles
- Position: In-tank
- Condition: New
Hard starting, stalling or sputtering under load, and a whine from the tank can mean a fuel pump is wearing out. A blown fuse or a clogged strainer can also starve the engine of fuel, so look at the fuse with the key off before you buy a pump.
Fits
This pump is listed for a wide range of Ford and Volvo models, including the 1987-1989 Ford F-250 6-cylinder 4.9L or V8 5.0L and the 1988-1989 F-250 V8 5.8L or 7.5L, and the 1986-1991 Ford E-150 Econoline V8 5.0L or 5.8L and the 1987-1991 E-150 Econoline 6-cylinder 4.9L. If your vehicle is not named here, look up its year and engine in the "Vehicles it fits" section.
Specifications
- Position: in-tank
- Quantity per vehicle: 1
- Condition: new
In the box
One electric fuel pump, an isolator, two plastic tube clamps, two retainer clips, three seals, a tube piece and an instruction sheet. This listing is one pump, and the engine needs just one.
Installation notes
- An instruction sheet comes with the pump for the steps.
- Check and clean the fuel tank before installing the pump.
- Replace the fuel strainer whenever you repair the fuel pump.
Frequently Asked Questions
Is the Delphi FE0070 listed for the 1987-1989 Ford F-250 with the 6-cylinder 4.9L or V8 5.0L?
Yes. Delphi FE0070 is listed for the 1987-1989 Ford F-250 6-cylinder 4.9L or V8 5.0L and the 1988-1989 F-250 V8 5.8L or 7.5L. If your vehicle is not named, look up its year and engine in the "Vehicles it fits" section.
What comes with the Delphi FE0070 besides the pump itself?
The Delphi FE0070 comes with an isolator, two plastic tube clamps, two retainer clips, three seals, a tube piece and an instruction sheet.
Does this electric fuel pump mount in the tank or somewhere else?
This is an in-tank pump. It sits inside the fuel tank rather than on the frame rail.
What symptoms can mean an in-tank fuel pump is wearing out?
Hard starting, stalling or sputtering under load, and a loud whine from the tank can mean the pump is wearing. Fuel pressure testing is a job for a shop.
Should I replace the fuel strainer when installing the Delphi FE0070?
Yes. Replace the fuel strainer whenever the fuel pump is repaired, and check and clean the fuel tank before the Delphi FE0070 goes in.
