Delphi FE0140 electric fuel pump for the 1995 Nissan Pickup 4-cylinder 2.4L or V6 3.0L and other vehicles sends fuel from the tank to the engine. This in-tank pump is built to Delphi's OE standards.
- Designed to operate under extreme temperatures with quick engine starts
- Fast pressure performance and system integrity, with less energy used for pumping
- Lower amperage draw, so less load on the vehicle's electrical system
- Validated and tested by Delphi
Quick facts
- Part: Delphi FE0140 electric fuel pump
- Fits: 1995 Nissan Pickup 4-cylinder 2.4L or V6 3.0L and other vehicles
- Position: In-tank
- Condition: New
A weak fuel pump can show up as hard starting, sputtering under load or stalling. A clogged fuel filter, a bad relay or a wiring fault can be behind these signs too, so find the cause before you buy a pump.
Fits
This in-tank pump is made for the 1986-1993 Nissan D21 4-cylinder 2.4L, the 1986-1994 D21 V6 3.0L and the 1990-1992 Infiniti M30 V6 3.0L. If your car is not named here, look up its year and engine in the "Vehicles it fits" section.
Specifications
- Position: In-tank
- Quantity per vehicle: 1
- Condition: New
In the box
One electric fuel pump, a connector with 2 wires, two hose clamps, a hose piece, an isolator, two splices, a washer and an instruction sheet. This listing holds one pump, and each vehicle takes one.
Installation notes
- Check and clean the fuel tank before installing the pump.
- Replace the fuel strainer whenever you do a fuel pump repair.
- An instruction sheet comes with the pump.
Frequently Asked Questions
Will the Delphi FE0140 fit a 1986-1993 Nissan D21 4-cylinder 2.4L?
Yes. Delphi FE0140 fits the 1986-1993 Nissan D21 4-cylinder 2.4L and the 1986-1994 D21 V6 3.0L. For other vehicles, look up your year and engine in the "Vehicles it fits" section.
What hardware comes with the Delphi FE0140 fuel pump?
The Delphi FE0140 comes with the pump, a connector with 2 wires, two hose clamps, a hose piece, an isolator, two splices, a washer and an instruction sheet.
Does this fuel pump mount inside the tank?
Yes. This is an in-tank pump. The listing is one pump, and the vehicle takes one.
Should the fuel strainer be replaced along with this pump?
Yes. The fuel strainer should be replaced any time the fuel pump is repaired, and the tank should be checked and cleaned first.
Does this fuel pump put less load on the electrical system?
Yes. The lower amperage draw means this pump puts less load on the vehicle's electrical system, and it is also designed for quick starts in extreme temperatures.
