Delphi FE0310 electric fuel pump for the 1990-1992 Ford Ranger V6 2.9L, the 1990-1997 Ranger 4-cylinder 2.3L or V6 4.0L, the 1991-1997 Ranger V6 3.0L and other vehicles moves fuel from the tank to the engine. This Delphi electric fuel pump mounts in the tank and is built to Delphi's OE standards.
- Designed to run in extreme temperatures with quick engine starts
- Designed to restore fast pressure performance and system integrity while using less energy
- Lower amperage draw puts less load on the vehicle's electrical system
- Validated and tested pump
Quick facts
- Part: Delphi FE0310 electric fuel pump
- Fits: the 1990-1992 Ford Ranger V6 2.9L, the 1990-1997 Ranger 4-cylinder 2.3L or V6 4.0L, the 1991-1997 Ranger V6 3.0L and other vehicles
- Position: In-tank
- Condition: New
A weak or failing pump can show up as hard starting, sputtering under load or a stall, though other parts can cause these too. Before you replace the pump, rule out a blown fuse, a bad relay and a clogged filter, since each of them can look like a failed pump.
Fits
This pump is listed for a wide range of Ford, Lincoln, Mazda and Mercury models, including the 1991-1994 Ford Explorer V6 4.0L, the 1989-1995 Ford Taurus V6 3.0L and the 1994-1995 Taurus V6 3.2L. It is matched to the right vehicle application.
Specifications
Fit and size
- Position: In-tank
- Quantity per vehicle: 1
Build and materials
- Type: Electric
- Condition: New
In the box
One electric fuel pump, two hose clamps, a hose piece, two retaining clips, four seals and an instruction sheet. This listing is one pump, and the vehicle takes one.
Installation notes
- Check and clean the fuel tank when you do the job.
- Replace the fuel strainer whenever you do a fuel pump repair.
- The instruction sheet in the box covers the installation steps.
Frequently Asked Questions
Is this pump right for the 1990-1992 Ford Ranger V6 2.9L?
Yes. Delphi FE0310 is listed for the 1990-1992 Ford Ranger V6 2.9L. If your car is not named on this page, check it in the "Vehicles it fits" section.
Which hardware comes with the Delphi FE0310?
The box holds the pump, two hose clamps, a hose piece, two retaining clips, four seals and an instruction sheet.
Does this fuel pump go inside the tank?
Yes. Delphi FE0310 is an in-tank electric fuel pump, so it mounts inside the fuel tank.
Should I replace the fuel strainer when installing this pump?
Yes. A new fuel strainer goes in with every fuel pump repair, and the tank should be checked and cleaned at the same time. The instruction sheet in the box covers the steps.
Does the Delphi FE0310 fit the 1989-1995 Ford Taurus V6 3.0L?
Yes. Delphi FE0310 is listed for the 1989-1995 Ford Taurus V6 3.0L and for the 1994-1995 Taurus V6 3.2L.
