Delphi Fuel Pump and Strainer Set P/N:FE0396
Delphi FE0214 fuel pump and strainer set for the 1998 Ford Mustang V6 3.8L moves fuel from the tank to the engine. This Delphi fuel pump is built to Delphi's OE standards, and the strainer comes in the same set.
A weak pump can show up as hard starting, stalling or a loss of power. A clogged fuel filter, a faulty fuel pump relay or a blown fuse can sit behind those signs as well, so track down the cause before you buy a pump.
This fuel pump and strainer set is a direct-fit replacement for the 1998 Ford Mustang V6 3.8L, which takes one.
One fuel pump and strainer set, seals, an isolator, a wire harness and connector, clips and an instruction sheet.
Does this Mustang fuel pump fit the 1998 Ford Mustang V6 3.8L?
Yes. Delphi FE0214 is listed for the 1998 Ford Mustang V6 3.8L, and that car takes one.
Does this Delphi fuel pump assembly come with the strainer and hardware?
Yes. The Delphi FE0214 set includes the fuel pump and strainer, seals, an isolator, a wire harness and connector, clips and an instruction sheet.
Is this Delphi technologies fuel pump validated and tested?
Yes. The part is validated, tested and matched to the right vehicle application.
Why replace the strainer with a Delphi fuel pump and strainer set?
The fuel strainer should always be replaced when the fuel pump is repaired, and this set supplies both. Check and clean the fuel tank at the same time.
Can this fuel pump and strainer set handle extreme temperatures?
Yes. The pump is designed to operate under extreme temperatures with quick engine starts, and its lower amperage draws less load on the vehicle's electrical system.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.