Delphi FE0485 fuel pump and strainer set for the 1999-2004 Ford F-250 Super Duty V8 5.4L or V10 6.8L and other vehicles pairs a replacement pump with its strainer to move fuel toward the engine. This Delphi fuel pump is built to Delphi's OE standards and is validated, tested and matched to the right vehicle application.
- Designed to operate under extreme temperatures with quick engine starts
- Lower amperage draw puts less load on the vehicle's electrical system
- Designed to bring back fast fuel pressure and system integrity while using less energy
- Fuel strainer supplied with the pump
Quick facts
- Part: Delphi FE0485 fuel pump and strainer set
- Fits: 1999-2004 Ford F-250 Super Duty V8 5.4L or V10 6.8L and other vehicles
- Condition: New
Hard starting, stalling or a loss of power can mean the pump is wearing out, though a clogged fuel filter or a faulty fuel pump relay can be behind them too, so find the cause before you replace anything. Each vehicle takes one set.
Fits
The set is a direct-fit replacement for the 2001 Ford Taurus V6 3.0L and the 1998 Ford Mustang V6 3.8L as well. Driving a different Ford or Mercury? Look up your year and engine in the "Vehicles it fits" section.
Specifications
- Quantity per vehicle: 1
- Type: fuel pump and strainer set
- Condition: New
In the box
One fuel pump and strainer set, seals, isolators, pall nuts, clips and an instruction sheet.
Installation notes
- Check and clean the fuel tank before fitting the new pump.
- Replace the fuel strainer whenever the fuel pump is repaired; this set includes one.
- The instruction sheet comes with the set.
Frequently Asked Questions
Will this Mustang fuel pump fit a 1998 Ford Mustang V6 3.8L?
Yes. Delphi FE0485 is listed for the 1998 Ford Mustang V6 3.8L, and that car takes one set. For other cars, look up your year and engine in the "Vehicles it fits" section.
Is this the 2001 Ford Taurus fuel pump for the V6 3.0L?
Yes. This pump and strainer set is listed for the 2001 Ford Taurus V6 3.0L, with one set per vehicle.
Is this Delphi fuel pump assembly just the pump?
No. Delphi FE0485 is a set: the pump comes with a strainer, seals, isolators, pall nuts, clips and an instruction sheet.
Do I need to replace the strainer when I change the fuel pump?
Yes. The strainer should always be replaced during a fuel pump repair, and this set includes one. Check and clean the fuel tank at the same time.
How does this pump handle heat and electrical load?
This fuel pump and strainer set is designed to operate under extreme temperatures with quick engine starts. Its lower amperage draw puts less load on the electrical system.
