Delphi FL0429 fuel tank sending unit for the 2009-2012 Toyota RAV4 V6 3.5L and the 2009-2018 RAV4 4-cylinder 2.5L reports the fuel level in the tank to your gas gauge.
- Empty float height and float retention are set for correct gas gauge reading
- Validated and tested, then matched to its vehicle application
Quick facts
- Part: Delphi FL0429 fuel tank sending unit
- Fits: the 2009-2012 Toyota RAV4 V6 3.5L and the 2009-2018 RAV4 4-cylinder 2.5L
- Condition: New
A worn sending unit can show up as a gas gauge that reads wrong, sticks in one spot or jumps around. Other causes can look the same, so with the engine off, start with the gauge fuse and leave sender and wiring tests to a shop. If the sending unit is the cause, this one replaces it.
Fits
Delphi builds this sending unit to its OE standards, and it is a direct-fit replacement for the 2009-2012 Toyota RAV4 V6 3.5L and the 2009-2018 RAV4 4-cylinder 2.5L.
Specifications
- Quantity per vehicle: 1
- Float arm: included
- Condition: New
In the box
One fuel tank sending unit with float arm, four screws and an instruction sheet. This listing holds one sending unit, and the vehicle takes one.
Installation notes
- Check and clean the fuel tank before fitting the new unit.
- Follow the instruction sheet that comes with the part for the steps.
Interchange: 83320-09140
4017358 · CFL0429 · P76860T · A16463 · FG306A
This part cross-references / interchanges with the following part numbers:
4017358, CFL0429, P76860T, A16463, FG306A, 83320-09140
Frequently Asked Questions
Does the Delphi FL0429 fit the 2009-2012 Toyota RAV4 V6 3.5L?
Yes. Delphi FL0429 fits the 2009-2012 Toyota RAV4 V6 3.5L, and it also fits the 2009-2018 RAV4 4-cylinder 2.5L.
Does the Delphi fuel tank sending unit include a float arm and screws?
Yes. Delphi FL0429 comes with the float arm, four screws and an instruction sheet. Nothing else is listed in the box.
Do the float height and retention on this sending unit match the original?
Yes. The empty float height and float retention match OE specifications, which is what gives a correct gas gauge reading.
What can a failing fuel tank sending unit do to the gas gauge?
The gauge can read empty or full when it should not, stick in one spot, or swing erratically while you drive.
Should the tank be cleaned before this sending unit goes in?
Yes. Check and clean the fuel tank first. The instruction sheet packed with the Delphi FL0429 covers the installation steps.
