Delphi FL0485 fuel tank sending unit for the 1996-1999 BMW 328i 6-cylinder 2.8L and other vehicles sends the tank's fuel level to the gas gauge. A float arm on the unit follows the fuel surface to make that reading, and Delphi builds every fuel tank sending unit to its OE standards.
- Empty float height and float retention set for a correct gas gauge reading
- Validated and tested part
Quick facts
- Part: Delphi FL0485 fuel tank sending unit
- Fits: the 1996-1999 BMW 328i 6-cylinder 2.8L and other vehicles
A fuel gauge that reads wrong, jumps around or sticks on one reading can mean the sending unit is worn. Before you replace it, rule out the gauge cluster and its wiring, since a fault there can throw off the reading as well.
Fits
The 1996-1999 BMW 328i 6-cylinder 2.8L, the 1996-1999 BMW 328is 6-cylinder 2.8L and the 1996-1999 BMW M3 6-cylinder 3.2L fit this fuel tank sending unit, along with other vehicles, and each takes one.
Specifications
- Engines: L6-2.5L, L6-2.8L, L6-3.2L
- Quantity per vehicle: 1
- Float arm: included
In the box
One fuel tank sending unit with float arm, seal, grommet, insulating sleeve and an instruction sheet.
Installation notes
- Check and clean the fuel tank before the new sending unit goes in.
- The instruction sheet in the box covers the installation steps.
Interchange: 16141182986 · 16141183364 · 16146758255 · USEP8416M
This part cross-references / interchanges with the following part numbers:
16141182986, 16141183364, 16146758255, USEP8416M
Frequently Asked Questions
Does the Delphi FL0485 fuel tank sending unit fit the 1996-1999 BMW M3 6-cylinder 3.2L?
Yes. Delphi FL0485 fits the 1996-1999 BMW M3 6-cylinder 3.2L and the 1996-1999 BMW 328is 6-cylinder 2.8L. For any other car, check the "Vehicles it fits" section on this page.
What parts come with the Delphi FL0485 fuel tank sending unit?
The Delphi FL0485 comes with the float arm, seal, grommet, insulating sleeve and an instruction sheet.
Is the float height on this fuel tank sending unit set for a correct gauge reading?
Yes. Its empty float height and float retention match OE specifications, which is what keeps the gas gauge reading correct.
How can I tell if this fuel tank sending unit is going bad?
A gas gauge that reads wrong, jumps around or sticks on one reading can mean the sending unit is failing. A shop can test the sending unit and the gauge circuit.
Should I clean the fuel tank when installing the Delphi FL0485?
Yes. Check and clean the fuel tank first, and follow the instruction sheet that comes with the part for the steps.
