Oxygen Sensor for 1993-1995 Ford F-150 & More - Delphi ES20014

Delphi ES20014 oxygen sensor for the 1993-1995 Ford F-150 V8 5.8L and other vehicles reports exhaust oxygen to the engine computer. Each Delphi oxygen sensor is built to Delphi's OE standards.

• Delphi planar technology that covers older, conical design sensors
• Smart design that consolidates SKUs without using long wires
• Patented protective sensor coating that helps prevent contamination
• Validated for all fuel types, including ethanol blends like E85
• Tested to 150,000 miles, plus 2,000 hours of severe thermal testing

Quick facts

• Part: Delphi ES20014 oxygen sensor
• Fits: 1993-1995 Ford F-150 V8 5.8L and other vehicles
• Position: Front, rear, rear right or center, depending on the vehicle
• Condition: New

A check engine light, a rough idle or higher fuel use can mean the sensor is worn, though an exhaust leak or damaged wiring can be behind them too, so find the cause before you replace it. This listing is one sensor; the 2007 Mazda CX-9 V6 3.5L takes two, while the 1993-1995 Ford F-150 V8 5.8L takes one.

Fits

The vehicles it fits include the 1993-1995 Ford F-150 V8 5.8L and the 2005-2008 Ford Escape 4-cylinder 2.3L, and it works as an oxygen sensor for the 2007 Mazda CX-9 V6 3.5L and the 2008-2010 CX-9 V6 3.7L. If your vehicle is not one of these, run its year, model and engine through the "Vehicles it fits" section.

Specifications

In the box

One oxygen sensor and one instruction sheet.