Keep dirt, grit, and moisture out of your steering gear with the Delphi Rack and Pinion Bellows Kit TBR5094. These protective bellows seal the front rack and pinion ends while letting the tie rods move through their full travel — a torn or split boot that lets contamination reach the rack is a common reason to fit new bellows. It installs on the front steering of the 1990-1993 Mazda 626 and the 1990-1994 Mazda MX-6; see the Buyer's Guide tab for engine-level details.
Interchange: 532-157
532157 · RPK851045 · RPK851045PR · 26003747 · GK9857 · MK9857
This part cross-references / interchanges with the following part numbers:
What does this bellows kit do?
The bellows seal the ends of the rack and pinion steering gear, keeping dirt, grit, and moisture out while allowing the tie rods to move through their full travel.
Which vehicles does the TBR5094 fit?
It fits the front steering of the 1990-1993 Mazda 626 and the 1990-1994 Mazda MX-6. Check the Buyer's Guide tab to confirm fitment for your vehicle.
How do I know my steering bellows need replacing?
Signs may include a torn, split, or cracked boot, or grease and road debris around the rack ends. If a failed bellows is letting contamination reach the rack, this kit replaces it.
Does the kit include the parts needed for installation?
Yes. Delphi includes the accessories needed to complete the job. Consult the vehicle service information for the correct procedure and torque specs.
Is this a Delphi OE-quality part?
Delphi designs this kit to OE standards and backs it with extensive dimensional and material analysis, testing from below -40°C to over 120°C plus 720 hours of salt spray exposure.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
