Keep steering input crisp and the front wheels tracking true with the Delphi Steering Tie Rod End TA1386, an inner tie rod end that ties the steering linkage to the wheel so your inputs translate into precise directional response. It drops in as a direct-fit replacement across a wide run of Mercedes-Benz sedans and coupes, including the 1992-1993 300SD, 300SE and 500SEL, the 1994-1999 S320, S420, S500 and S600, and the 1998-1999 CL500 and CL600 — see the Buyer's Guide tab for the full list of covered models, years and engines.
Delphi carries its OE steering expertise into the aftermarket, with parts validated against extremes below -40°C and above 120°C plus 720 hours of salt-spray exposure, and dimensional and material analysis for close OE-to-aftermarket compatibility.
- Micron-tolerance ball stud: machined to fine tolerances for durability and smooth joint movement.
- Fatigue tested: validated to resist failure under repeated steering loads.
- Anti-corrosion protection: applied to each part for corrosion prevention and improved appearance.
- Accessories included: ships with the hardware Delphi specifies for the job.
Worn tie rod ends can show up as loose or wandering steering, uneven front tire wear, or a clunk when turning; if a failed inner tie rod end is the cause, this replaces it. Have an alignment performed after installation.
Interchange: 101-5206 · MB-T216 · 001 330 63 35 · A001 330 6335
1015206 · MBT216 · 0013306335 · A0013306335 · TI28035 · TI28035PR · ES3574A · MS10739 · JTE388
This part cross-references / interchanges with the following part numbers:
101-5206, MB-T216, TI28035, TI28035PR, ES3574A, 001 330 63 35, A001 330 6335, MS10739, JTE388
