Keep steering input flowing cleanly from the linkage to the front wheel with the Delphi Steering Tie Rod End TA1465, an outer tie rod end that connects the steering system to the steering knuckle and lets the wheel pivot while transmitting your steering motion. It drops in as a direct-fit replacement across a wide range of classic BMW, Mercedes-Benz and Porsche models — including the BMW 2002 (1968-1976), Mercedes-Benz 280SE, 450SL (1973-1980) and Porsche 911 (1978-1989). This part fits 56 applications in total, so check the Buyer's Guide tab for the full year, make, model and engine list.
OE-derived safety technology: Delphi applies its OE steering expertise to the aftermarket, with extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
Tested to the extreme: validated below -40°C and over 120°C and exposed to 720 hours of salt spray.
Micron-tolerance ball studs: machined to fine tolerances for durable, smooth joint operation, and fatigue tested to help avoid failure.
Anti-corrosion protection: applied to each part for corrosion prevention and improved appearance.
Comes with the accessories needed to complete the job. Signs an outer tie rod end may need replacing include loose or wandering steering, uneven tire wear, clunking, or play felt at the wheel. Sold individually; order the quantity your vehicle requires and have an alignment performed after installation.
Frequently Asked Questions
What does this tie rod end do?
It connects the outer end of the steering linkage to the steering knuckle, transmitting your steering input to the front wheel while allowing the wheel to pivot and move with the suspension.
Is this an inner or outer tie rod end?
The Delphi TA1465 is an outer tie rod end. Confirm the correct fitment for your vehicle in the Buyer's Guide tab before ordering.
How do I know if my tie rod end is worn?
Common signs include loose or wandering steering, a clunk from the front end, uneven or accelerated tire wear, and play felt at the wheel. Have the cause diagnosed before replacing.
What vehicles does the TA1465 fit?
It fits 56 classic BMW, Mercedes-Benz and Porsche applications, such as the BMW 2002, Mercedes-Benz 450SL and Porsche 911. See the Buyer's Guide tab for the full list.
Do I need an alignment after installing it?
Yes. Replacing a tie rod end affects toe settings, so a wheel alignment should be performed afterward for proper steering and even tire wear.
Steering Tie Rod EndDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
