Keep steering tight and responsive with the Delphi Steering Tie Rod End TA1889, an outer tie rod end that links the steering linkage to the knuckle and transmits your steering input to the front wheel while allowing for suspension travel. It drops in as a direct-fit replacement for the 1994-2001 Kia Sephia and 2000-2004 Kia Spectra — see the Buyer's Guide tab for engine-level fitment.
- OE-grade validation: built on Delphi's OE steering expertise and tested to the extreme — the part withstands temperatures below -40°C and over 120°C and endures 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
- Machined ball stud: the ball stud is machined to micron tolerances for durability and smooth joint operation.
- Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance.
- Ready to install: fatigue tested to help avoid failure, and includes the necessary accessories for a complete job.
A worn tie rod end often shows up as loose or wandering steering, uneven front tire wear, or a clunk when turning. If a failed outer tie rod end is the cause of those signs, replacing it with TA1889 restores the connection. Have your alignment checked after installation.
Interchange: 101-4437 · 101-4985 · 0K201-32-280 · 0K201-32-280A · 0K9A2-32-280
1014437 · 1014985 · 0K20132280 · 0K20132280A · 0K9A232280 · T3377XL · ER02102 · ER19154 · OK20132280A · OK9A232280 · T3377 · T3403 · TO63025 · TO63025XL · TO63105 · ES3377 · ES3403 · GES3377 · MES3377 · MES3402 · MES3403 · JTE7537
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What vehicles does the Delphi TA1889 tie rod end fit?
It fits the 1994-2001 Kia Sephia and the 2000-2004 Kia Spectra. Check the Buyer's Guide tab to confirm engine-level fitment for your specific vehicle.
Is this an inner or outer tie rod end?
This is an outer tie rod end, which connects the steering linkage to the steering knuckle.
What does a tie rod end do?
It transmits steering motion from the linkage to the front wheel while allowing the suspension to move, keeping the steering connection tight and controlled.
What are the signs a tie rod end may need replacing?
Common signs include loose or wandering steering, uneven front tire wear, and a clunk when turning. Have the cause diagnosed, since these can have other sources.
Do I need a wheel alignment after installing this?
Yes. Replacing a tie rod end changes toe settings, so have a wheel alignment performed afterward for correct handling and even tire wear.
Write a Review