Tighten up loose steering and restore precise wheel control with the Delphi inner tie rod end (TA2049). This inner joint links the steering gear to the outer tie rod, transferring steering input to the front wheels — worn units show up as loose or wandering steering, uneven front tire wear, and clunking or play when turning. It's a direct-fit replacement for the 2004-2011 Volvo S40, 2005-2011 Volvo V50, 2006-2013 Volvo C70, and 2007-2013 Volvo C30; see the Buyer's Guide tab for engine-level fitment.
- OE-derived engineering: Delphi applies its OE steering expertise to the aftermarket line, tested from below -40°C to over 120°C and through 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
- Micron-machined ball stud: the ball stud is machined to micron tolerances for durability and smooth joint operation.
- Fatigue tested: Delphi tie rods are fatigue tested to help avoid failure.
- Corrosion protected: anti-corrosion protection is applied for corrosion prevention and improved appearance, and the necessary accessories are included for the job.
If a worn inner tie rod end is behind your steering play, this Delphi track rod end drops in as the replacement. A Volvo S40 tie rod end job is a good time to inspect the mating outer joint as well.
Interchange: 101-5193 · 612.39008
1015193 · 61239008 · 1251937 · 1510270 · 3M513L519AA · 3M513L519AB · AX07198 · TI45070 · TI45070XL · EV800458 · GS10725 · MS10725 · JAR1022 · 274502 · 30776283
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What is the Delphi TA2049 tie rod end?
It's an inner steering tie rod end that connects the steering gear to the outer tie rod, transferring steering input to the front wheel. It fits the listed Volvo C30, C70, S40, and V50 models.
What are the signs I need to replace this tie rod end?
Common signs are loose or wandering steering, a clunking noise or play when turning, and uneven front tire wear. Have the steering diagnosed to confirm the inner tie rod end is the cause.
Which vehicles does the Delphi TA2049 fit?
It's a direct-fit replacement for the 2004-2011 Volvo S40, 2005-2011 Volvo V50, 2006-2013 Volvo C70, and 2007-2013 Volvo C30. Check the Buyer's Guide tab for engine-level fitment.
Is this a Delphi track rod end built to OE standards?
Yes. Delphi applies its OE steering expertise to this part, testing from below -40°C to over 120°C and through 720 hours of salt spray, with dimensional and material analysis for OE compatibility.
Does the Delphi tie rod end come with what I need to install it?
Delphi includes the necessary accessories for the job. Always follow the vehicle service information for correct fasteners, torque, and whether an alignment is required after installation.
Write a Review