Sharpen steering response and keep your front wheels tracking true with the Delphi Steering Tie Rod End TA2167, the right-side outer joint that links the steering linkage to the knuckle and transmits your steering input to the wheel. It installs as a direct-fit replacement across a wide Ford and Mazda range, including the 1980-1996 Ford Bronco, 1980-1994 Ford F-150, 1980-1997 Ford F-250 and F-350, 1983-1997 Ford Ranger and 1994-1997 Mazda B2300, B3000 and B4000 — see the Buyer's Guide tab for the full list of applications.
- Tested for OE performance: Delphi validates the joint from below -40°C to over 120°C and through 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
- Micron-tolerance ball stud: the threaded ball stud is machined to micron tolerances for durable, smooth joint operation, and the assembly is fatigue tested.
- Corrosion protection: anti-corrosion protection is applied to each part for corrosion prevention and enhanced appearance.
- Ready to install: pre-greased with a grease fitting and the necessary mounting hardware included for a complete job.
The steel tie rod end uses a steel housing, a plastic bearing and a rubber dust boot, and is a non-adjustable, standard-replacement unit. A worn tie rod end can show up as loose or wandering steering, uneven tire wear, or a knocking feel when turning; if a failed outer tie rod end is the cause, this replaces it — have the steering and suspension inspected to confirm the fault before installing. Country of origin: Turkey.
Manufacturer part number TA2167.
This part cross-references / interchanges with the following part numbers:
101-4702, 613.65044, T2214, T2077, T3342, ES2077R, ES2077RT, ES3342R, ES800524, ZZM0-32-280, GES2077RT, GES3342R, MES2077RT, MES3342R, JTE1542, JTE7058
