Help address loose, wandering steering with the Delphi tie rod, an inner steering tie rod end (MPN TA3046) that connects the steering rack to the outer tie rod so your steering inputs reach the front wheels. It drops in as a direct-fit replacement for the 2000-2006 Toyota Tundra and 2001-2007 Toyota Sequoia — see the "Vehicles it fits" section for the full engine-level fitment.
Delphi applies its OE steering expertise to this aftermarket joint, testing to the extreme for OE-level performance: parts endure temperatures below -40°C and above 120°C plus 720 hours of salt spray, with extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
- Micron-tolerance ball stud: machined to micron tolerances for durability and smooth joint operation.
- Fatigue tested: Delphi tie rods are fatigue tested to help avoid failure.
- Anti-corrosion protection: applied to each part for corrosion prevention and enhanced aesthetics.
- Complete job: includes the necessary accessories for the installation.
If a worn inner tie rod end is behind your loose steering, uneven tire wear, or excess steering play, this is the part to replace. This 2000-2006 Toyota Tundra inner tie rod handles the same steering job as the original.
Interchange: 101-4841 · 613.44054 · 45503-09120
1014841 · 61344054 · 4550309120 · AX07014 · TI74370 · TI74380 · TI74380XL · EV800444 · GS86702 · MS86702 · JAR1116 · 4550309240
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
101-4841, 613.44054, AX07014, TI74370, TI74380, TI74380XL, EV800444, GS86702, MS86702, JAR1116, 45503-09120, 4550309240
Frequently Asked Questions
What vehicles does this Delphi tie rod end fit?
It is a direct-fit replacement for the 2000-2006 Toyota Tundra and 2001-2007 Toyota Sequoia. Check the "Vehicles it fits" section to confirm the fitment for your specific vehicle.
Is this an inner or outer tie rod end?
This is an inner tie rod end (MPN TA3046). It connects the steering rack to the outer tie rod on the listed applications.
What are the signs my inner tie rod may need replacing?
Common signs include loose or wandering steering, uneven tire wear, and play or looseness in the steering. Have the cause diagnosed, since these symptoms can have other sources.
Does this tie rod replacement include installation hardware?
Delphi includes the necessary accessories for a complete job. Consult the vehicle service information for correct torque specs and installation procedure.
How is this Delphi tie rod built for durability?
The ball stud is machined to micron tolerances for smooth operation, the joint is fatigue tested, and anti-corrosion protection is applied to each part.
