Delphi TA3597 tie rod end for the 2020-2025 Mercedes-Benz GLE350 and other vehicles is an inner joint in the steering linkage that carries steering input toward the wheel.
- Uses Delphi's OE safety technology, with dimensional and material analysis behind its compatibility with the OE part.
- Withstands temperatures below -40 degrees C and over 120 degrees C and 720 hours of salt spray.
- Includes the necessary accessories for a complete job.
- Ball studs are machined to micron tolerances for durability and smooth joint operation.
- Delphi tie rods are fatigue tested to avoid failure.
- Anti-corrosion protection is applied to each part.
A worn steering tie rod end can show up as loose or vague steering, a clunk from the steering or uneven tire wear. Outer tie rod ends, ball joints, control arm bushings and a bad alignment can cause those signs too, so find the cause before you buy.
It fits the 2020-2025 Mercedes-Benz GLE450 and the 2022-2025 Mercedes-Benz GLE450 SUV, which each take two, one on each side of the axle. The quantity varies by model, and this listing is a single tie rod end, so the other side of that axle is normally done at the same time. If your Mercedes-Benz isn't one of these, find its year and model in the "Vehicles it fits" section.
Specifications
Fit and size
- Position: Inner
- Quantity per vehicle: 1 or 2, depending on the model
- Sold as: one tie rod end per listing
Build and materials
- Ball studs: machined to micron tolerances
- Finish: anti-corrosion protection on each part
- Country of origin: Turkey
Interchange: 167-338-00-00
1018751 · KRE4189 · MS107114
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
1018751, KRE4189, 167-338-00-00, MS107114
Frequently Asked Questions
Does the Delphi TA3597 tie rod end fit the 2020-2025 Mercedes-Benz GLE350?
Yes. Delphi TA3597 is listed for the 2020-2025 Mercedes-Benz GLE350, which takes two, one on each side. For other years and models, look yours up in the "Vehicles it fits" section.
Is this Delphi track rod end an inner or outer part?
It is an inner tie rod end. Delphi TA3597 is listed with the Inner position, so it is not an outer tie rod end.
Besides a Delphi tie rod review, how are the ball studs on this tie rod end made?
The ball studs are machined to micron tolerances for durability and smooth joint operation. This tie rod end is also fatigue tested to avoid failure.
How can I tell if an inner tie rod end is worn?
Loose or vague steering, a clunk from the steering or uneven tire wear can be signs of a worn inner tie rod end. A shop can measure play in the joint to confirm.
Does Delphi TA3597 replace number KRE4189?
Yes. KRE4189 is one of the numbers Delphi TA3597 replaces, along with 167-338-00-00, 1018751 and MS107114.
