Delphi Steering Tie Rod End P/N:TA2325
Help keep steering response tight and predictable with the Delphi tie rod end TA5066, an outer tie rod end that connects the steering linkage to the steering arm at the wheel and carries your steering input to it. It fits many vehicles, among them the 1971-1979 Volkswagen Super Beetle, 1967-1979 Volkswagen Transporter and 1968-1978 Volkswagen Beetle. See the Buyer's Guide tab for the full list. It is a direct-fit replacement for the listed applications and is cataloged for the outer position on both the left and right sides.
This Delphi steering tie rod end draws on Delphi's OE safety technology, which is fitted to millions of vehicles worldwide. Delphi applies that OE expertise to its aftermarket steering range, and it supplies the accessories needed to complete the job.
Delphi's extensive dimensional and material analysis aims for close compatibility between the OE part and its aftermarket replacement. Loose or wandering steering, a clunk when turning, or uneven tire wear are signs this part may need replacing. Other steering and suspension faults can cause the same symptoms, so inspect before replacing. Have a wheel alignment done after installation.
Interchange: 101-3396 · 311 415 812 B
1013396 · 311415812B · TO43015 · TO43015XL · ES419R · MES419R · JTE351 · 113415812C
This part cross-references / interchanges with the following part numbers:
What does this tie rod end do?
It connects the steering linkage to the steering arm at the wheel, passing steering input from the linkage to turn the wheel. TA5066 is cataloged for the outer position.
Is a Delphi track rod end the same as a tie rod end?
Yes. "Track rod end" is the common British name for a tie rod end. TA5066 is an outer tie rod end, listed for both the left outer and right outer positions.
Which vehicles does Delphi TA5066 fit?
It fits many vehicles, including the 1971-1979 Volkswagen Super Beetle, 1967-1979 Volkswagen Transporter and 1968-1978 Volkswagen Beetle. Check the Buyer's Guide tab for your exact vehicle.
What are signs a tie rod end may need replacing?
Common signs include loose or wandering steering, a clunk when turning, and uneven tire wear. Other steering or suspension faults can cause these too, so inspect before replacing.
Do I need a wheel alignment after installing it?
Yes. A wheel alignment is recommended after replacing a tie rod end because the job can change toe settings. Follow the vehicle service information for installation and torque.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.