If the 2003-2010 Dodge Ram 2500 tie rod end at your pitman arm is worn, the Delphi TA5170 Tie Rod End is a direct-fit replacement for it and for the 2003-2010 Dodge Ram 3500. This steering tie rod end is the pivoting ball-stud joint in the steering linkage. It mounts at the pitman arm, helps transfer steering movement, and lets the linkage pivot as the suspension travels.
Delphi brings the expertise behind its OE safety technology to its aftermarket steering line. Parts are tested for performance at temperatures below -40°C and above 120°C and through 720 hours of salt-spray exposure. Dimensional and material analysis is used to help this part match the original.
- Machined ball stud: machined to micron tolerances for durability and smooth joint operation.
- Fatigue tested: Delphi tie rods are fatigue tested to help avoid failure.
- Anti-corrosion protection: applied to each part to help prevent corrosion and improve its appearance.
- Accessories included: Delphi supplies the accessories it specifies for the job.
Signs a tie rod end may need replacing include excess play or looseness in the steering, wandering, a clunk when turning, and uneven tire wear. Diagnose the cause before replacing parts, and have the alignment checked after installation. See the "Vehicles it fits" section for full fitment details.
Interchange: 68036 940AA · 68036 940AC
TI81031 · TI81031XL · ES800375 · MS25709 · JTE1371 · 68036940AA · 68036940AC
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
68036 940AA, 68036 940AC, TI81031, TI81031XL, ES800375, MS25709, JTE1371
Frequently Asked Questions
Is the TA5170 the right tie rod end for a 2003-2010 Dodge Ram 3500?
It is a direct-fit replacement at the pitman arm for the 2003-2010 Dodge Ram 3500 and the 2003-2010 Dodge Ram 2500. Check your exact vehicle in the "Vehicles it fits" section.
Where does this Delphi tie rod end install?
It installs at the pitman arm in the steering linkage. It is the pivoting ball-stud joint that helps transfer steering movement.
How is this tie rod end tested?
Delphi tests its parts for performance below -40°C and above 120°C and through 720 hours of salt spray. Its tie rods are also fatigue tested.
What are signs a tie rod end may need replacing?
Common signs include loose or wandering steering, excess play, a clunk when turning and uneven tire wear. Other steering parts can cause these too, so diagnose the cause first.
What comes with it, and what should I do after installing it?
Delphi supplies the accessories it specifies for the job. Follow the vehicle service information for installation steps and torque values, then have the alignment checked.
