Tie Rod End for 2018-2022 Chevrolet Traverse & More - Delphi TA6436

The Delphi TA6436 tie rod end for the 2018-2022 Chevrolet Traverse and other vehicles is the left outer link that connects the steering linkage to the wheel's steering knuckle.

• Delphi's OE safety technology is fitted to millions of vehicles worldwide, and that OE expertise goes into its aftermarket steering line.
• Extensive dimensional and material analysis is done for compatibility between the OE part and this aftermarket part.
• Withstands temperatures below -40 degrees C and over 120 degrees C, and is exposed to 720 hours of salt spray.
• Ball studs are machined to micron tolerances for durability and smooth joint operation.
• Delphi tie rods are fatigue tested to avoid failure.
• Anti-corrosion protection is applied to each part.

A worn steering tie rod end can show up as loose or wandering steering, a clunk when turning, or uneven tire wear. Worn ball joints, control arm bushings or wheel bearings can cause some of the same signs, so find the actual cause before you buy. Replace the left and right ends together, since the axle takes one on each side and this listing is a single left outer end.

The 2017-2022 GMC Acadia and 2018-2022 Buick Enclave are among the vehicles this tie rod end fits as a direct-fit replacement, and cars not named here are listed in the "Vehicles it fits" section.

Specifications

In the box

The tie rod end and the necessary accessories for a complete job.

Interchange: 23214215 · TO90441 · TO90441XL · ES801409 · MS506111