Tie Rod End for 2018-2022 Chevrolet Traverse & More - Delphi TA6437

Delphi TA6437 tie rod end for the 2018-2022 Chevrolet Traverse and other vehicles is a right outer part that links the inner tie rod to the steering knuckle, also called a steering tie rod end.

• Withstands temperatures below -40 degrees C and over 120 degrees C, and is exposed to 720 hours of salt spray
• Dimensional and material analysis aims at close compatibility between the OE and aftermarket part
• Comes with the necessary accessories for a complete job
• Ball studs are machined to micron tolerances for durability and smooth joint operation
• Delphi tie rods are fatigue tested to avoid failure
• Anti-corrosion protection is applied to each part

Loose or wandering steering, uneven front tire wear or a clunk when turning can mean a tie rod end is worn, though worn control arm bushings or a bad wheel bearing can be behind them too, so pin down the cause before buying parts. Left and right tie rod ends are normally replaced together; this listing is one right outer unit, and the vehicle takes one on each side.

The vehicles it fits include the 2017-2022 GMC Acadia and the 2018-2022 Buick Enclave as direct-fit replacements. If your car isn't named here, look it up in the "Vehicles it fits" section.

Specifications

• Position: right outer
• Quantity per application: 1
• Corrosion protection: anti-corrosion protection applied to each part

Interchange: 23214216 · MS506112

Product information is for general reference and may contain errors. See our Disclaimer.