Delphi TA5444 inner tie rod for the 1980-1989 Subaru GL and other vehicles carries steering movement from the rack toward the wheels. This Delphi tie rod is also called a steering tie rod.
- Fatigue tested to avoid failure
- Anti-corrosion protection applied to the tie rod
- Ball studs machined to micron tolerances for smooth joint operation
- Withstands temperatures below -40 °C and over 120 °C, and is exposed to 720 hours of salt spray in testing
Quick facts
- Part: Delphi TA5444 inner tie rod
- Also called: steering tie rod
- Fits: 1980-1989 Subaru GL and other vehicles
- Position: Inner
- Condition: New
Loose or wandering steering, a clunk when turning, or uneven tire wear can mean a worn inner tie rod. These signs alone do not prove the tie rod is at fault, since a worn wheel bearing can feel similar.
Fits
As an inner tie rod, it is listed for the 1980-1989 Subaru GL, the 1980-1987 Subaru Standard and the 1982-1987 Subaru Brat. The 1980-1989 Subaru GL takes two; this listing is one, and the other side of the axle is normally done at the same time. If your Subaru is not one of these, look it up on the Buyer's Guide tab.
Specifications
Fit and size
- Position: Inner
- Quantity per vehicle: 2
Build and materials
- Condition: New
- Finish: anti-corrosion protection
In the box
One inner tie rod with the accessories needed for the job.
Interchange: 101-4024 · 7313-10011 · 7313-10060
IS177PR · EV177 · GEV177 · MEV177
This part cross-references / interchanges with the following part numbers:
101-4024, IS177PR, EV177, GEV177, MEV177, 7313-10011, 7313-10060
