Keep your steering precise and your suspension pivoting smoothly with the Delphi Suspension Ball Joint TC1317, a direct-fit replacement for a wide range of Audi and Volkswagen applications, including the 2006-2013 Audi A3, 2015-2018 Audi Q3, 2012-2019 Volkswagen Beetle, 2005-2018 Volkswagen Jetta, and 2012-2022 Volkswagen Passat (All engines) — see the Buyer's Guide tab for the full list.
- Forged construction: manufactured with high-quality forgings for increased strength and smooth operation.
- Chloroprene rubber boot: a durable dust boot that helps keep contaminants out and prevent premature failure.
- OE-level testing: tested below -40°C and above 120°C and through 720 hours of salt spray, with dimensional and material analysis for OE-to-aftermarket compatibility.
- Anti-corrosion protection: applied to each part to help prevent corrosion and improve appearance.
This ball joint forms the pivoting connection between the control arm and the steering knuckle, supporting vehicle load while letting the wheel steer and the suspension travel. Signs the joint may need replacing include clunking or knocking over bumps, loose or wandering steering, and uneven tire wear; if a worn ball joint is the cause, this unit replaces it. Machined to micron tolerances for smooth operation, it installs as a bolt-in part through three mounting holes and includes the mounting bolts and washers. It is not adjustable and does not include a grease fitting, castle nut, or cotter pin. Country of origin: Turkey. Manufacturer part number TC1317; GTIN 00689604251782.
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What vehicles does the Delphi TC1317 ball joint fit?
It's a direct-fit replacement for many Audi and Volkswagen models, including the 2006-2013 Audi A3, 2015-2018 Audi Q3, 2012-2019 VW Beetle, 2005-2018 VW Jetta, and 2012-2022 VW Passat. See the Buyer's Guide tab for the full list.
What does a suspension ball joint do?
It forms the pivoting connection between the control arm and the steering knuckle, supporting vehicle load while allowing the wheel to steer and the suspension to move up and down.
What are signs my ball joint may need replacing?
Common signs include clunking or knocking over bumps, loose or wandering steering, and uneven tire wear. Diagnose the cause first, since these symptoms can have other sources.
Does the TC1317 include mounting hardware?
Yes. It's a bolt-in unit that includes the mounting bolts and washers. It does not include a grease fitting, castle nut, or cotter pin.
Where is the TC1317 made, and is it adjustable?
The country of origin is Turkey, and this ball joint is not adjustable.
Write a Review