Delphi Suspension Ball Joint P/N:TC1675
Keep steering tight and suspension travel controlled with the Delphi Suspension Ball Joint TC2255, a front lower ball joint that drops in as a direct-fit replacement for the 2000-2006 Mitsubishi Montero (see the Buyer's Guide tab for engine details). This pivot joint connects the lower control arm to the steering knuckle, letting the wheel steer and the suspension articulate while carrying and locating the load at the front lower position.
Forged strength: Manufactured from high-quality forgings for increased strength and smooth operation.
Chloroprene rubber boots: Improve durability and help prevent premature failure by keeping grease in and contaminants out.
Micron-tolerance machining: Machined to micron tolerances for durability and smooth joint operation.
Anti-corrosion protection: Applied to each part for corrosion prevention and enhanced appearance.
Delphi's OE expertise carries into its aftermarket steering line: parts are tested to withstand temperatures below -40°C and over 120°C and are exposed to 720 hours of salt spray, with extensive dimensional and material analysis for OE-to-aftermarket compatibility. Signs this ball joint may need replacing include clunking on acceleration or over bumps, loose or wandering steering, and uneven tire wear; have the cause diagnosed before replacing.
Interchange: 101-4848 · 505-1325
1014848 · 5051325 · BJ11011 · BJ67025 · BJ67025PR · K90673 · FA2239 · MK90673 · MR496799 · JBJ7548
This part cross-references / interchanges with the following part numbers:
What vehicle does the Delphi TC2255 ball joint fit?
It is a direct-fit replacement for the 2000-2006 Mitsubishi Montero. Check the Buyer's Guide tab to confirm the engine and application for your specific vehicle.
Where is this ball joint located?
It is the front lower ball joint, connecting the lower control arm to the steering knuckle so the wheel can steer while the suspension articulates and carries load.
What material are the boots made from?
Delphi uses chloroprene rubber boots, which improve durability and help prevent premature failure by keeping grease sealed in and dirt and moisture out.
What are signs this ball joint may need replacing?
Common signs include clunking on acceleration or over bumps, loose or wandering steering, and uneven tire wear. Diagnose the cause before replacing, as other parts can produce similar symptoms.
Should I replace both ball joints at once?
Replacing both sides together is recommended for balanced handling. This listing is for one ball joint.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.