Keep your steering tight and your front suspension pivoting smoothly with the Delphi ball joint TC5915, a front lower suspension ball joint that drops in as a direct-fit replacement for the 1994-1998 Nissan 240SX. This pivoting joint connects the front lower control arm to the steering knuckle, letting the suspension travel and the wheel steer while helping support and locate the front end.
Delphi builds on its OE expertise for the aftermarket, testing to extremes for OE-level performance:
- Forged construction: Manufactured with high-quality forgings for increased strength and smooth operation.
- Chloroprene rubber boot: Improves durability and helps prevent premature failure by keeping contaminants out.
- Micron-tolerance machining: Machined to micron tolerances for durability and smooth joint operation.
- Corrosion protection: Anti-corrosion protection applied to each part for corrosion prevention and enhanced appearance.
Validated across temperatures below -40°C to over 120°C and 720 hours of salt spray, with dimensional and material analysis for OE-to-aftermarket compatibility. If a worn front lower ball joint is behind clunking, loose steering, or uneven tire wear, this Delphi unit replaces it. See the "Vehicles it fits" section for engine details.
Interchange: 40160-70T00
4016070T00 · B9820 · B9820XL · K9820 · GK9820 · MK9820 · JBJ963
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
40160-70T00, B9820, B9820XL, K9820, GK9820, MK9820, JBJ963
Frequently Asked Questions
Does this Delphi ball joint fit a 1994-1998 Nissan 240SX?
Yes. The Delphi TC5915 is a direct-fit front lower suspension ball joint for the 1994-1998 Nissan 240SX. Check the "Vehicles it fits" section to confirm the match for your vehicle.
What position is this ball joint?
It is the front lower ball joint, connecting the front lower control arm to the steering knuckle.
What are the signs my ball joint may need replacing?
Clunking over the front end, loose or wandering steering, or uneven tire wear can point to a worn ball joint. Have the cause diagnosed, since these signs can have other sources.
What is the boot made of?
It uses a chloroprene rubber boot, which improves durability and helps prevent premature failure by keeping contaminants out of the joint.
Is this ball joint corrosion protected?
Yes. Anti-corrosion protection is applied to each part for corrosion prevention and enhanced appearance, and Delphi validates parts through 720 hours of salt spray.
