Delphi ball joint TC747 is a front lower ball joint that acts as the pivot between the suspension and the steering knuckle, helping the wheel steer and travel smoothly. It fits many vehicles, among them the 1993-1995 Toyota Corolla, 1998-2002 Chevrolet Prizm and 1994-1999 Toyota Celica, as a direct-fit replacement for the listed applications. See the "Vehicles it fits" section for the full list and engine details.
Delphi applies the expertise behind its OE safety technology, which is fitted to millions of vehicles worldwide, to its aftermarket steering line. Its parts are tested hard: they withstand temperatures below -40°C and above 120°C and go through 720 hours of salt spray exposure. Delphi's dimensional and material analysis is aimed at close compatibility between the original part and the aftermarket part.
- Forged construction: made from high-quality forgings for increased strength and smooth operation.
- Chloroprene rubber boots: help improve durability and are designed to guard against premature failure.
- Micron-tolerance machining: machined to micron tolerances for durability and smooth joint operation.
- Anti-corrosion protection: applied to each part to help prevent corrosion and improve its appearance.
Planning a 1993-1995 Toyota Corolla ball joint replacement? Inspect the joint and the surrounding suspension parts first. Clunks and wandering steering can have other causes. If a worn front lower ball joint is the source, this Delphi TC747 replaces it.
Product information is for general reference and may contain errors. See our Disclaimer.
Frequently Asked Questions
Is this the correct 1993-1995 Toyota Corolla ball joint?
Yes. Delphi TC747 is listed as a front lower ball joint for the 1993-1995 Toyota Corolla. The "Vehicles it fits" section shows every listed application.
Does it work as a 1994-1999 Toyota Celica ball joint?
Yes. It is listed as a front lower ball joint for the 1994-1999 Toyota Celica, and it is a direct-fit replacement for the listed applications.
What does a suspension ball joint do?
It is a pivot that connects the control arm to the steering knuckle. It lets the wheel turn for steering while moving up and down with the suspension.
What are signs a ball joint may need replacing?
Common signs include clunking over bumps, loose or wandering steering, uneven tire wear, or play in the joint. Diagnose the cause first, because other suspension parts can produce the same symptoms.
How is this Delphi ball joint built and tested?
It is made from high-quality forgings, uses chloroprene rubber boots and is machined to micron tolerances. Delphi tests its parts below -40°C and above 120°C, with 720 hours of salt spray.
