Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC9116
Link the front wheel to the chassis and let it pivot smoothly as you steer with the Delphi control arm TC1710, a control arm with ball joint made for the front right upper position. It fits many vehicles, among them the 1997-2003 Ford F-150, 1997-1999 Ford F-250 and 1997-2002 Ford Expedition, as a direct-fit replacement for the listed applications. See the Buyer's Guide tab for the full list.
Delphi brings the expertise behind its OE safety technology, used on millions of vehicles worldwide, to its aftermarket steering line. Its dimensional and material analysis is aimed at close compatibility between the OE part and this replacement.
Clunking over bumps, loose or wandering steering and uneven tire wear are signs this part may need replacing. Have the front suspension inspected to find the cause first. If the original arm or its ball joint is worn, this assembly replaces both. This listing covers the right-side upper arm. Replacing both sides together is recommended, and a wheel alignment is generally advised afterward.
Interchange: 622.65088 · 520-216 · 520-218 · 5L3Z-3084-B · F65Z-3084-AB · F75Z-3084-AA · XL3Z 3084-AA
62265088 · 520216 · 520218 · 5L3Z3084B · F65Z3084AB · F75Z3084AA · XL3Z3084AA · CB8724 · CB8728 · CB8728PR · CK622997 · CK8724T · CK8728T · K8728T · RK8724 · RK8728 · CMK8728T · CTXK8728T · GK8728T · JTC7007
This part cross-references / interchanges with the following part numbers:
Will this F-150 control arm fit my 1997-2003 Ford F-150?
Yes. The Delphi TC1710 is listed for the 1997-2003 Ford F-150 in the front right upper position. Check the Buyer's Guide tab to confirm your exact vehicle.
What does a control arm and ball joint assembly do?
It connects the steering knuckle to the vehicle's frame so the suspension can move up and down. The ball joint lets the knuckle pivot as you steer.
How does Delphi test this control arm?
Delphi control arms go through crack detection and ultrasonic flaw detection. Its parts are also tested from below -40°C to over 120°C, with 720 hours of salt spray exposure.
What are the signs a control arm may need replacing?
Clunking over bumps, loose or wandering steering and uneven tire wear can point to a worn arm or ball joint. Have the suspension inspected to confirm the cause before replacing.
Is anything needed after installation?
A wheel alignment is generally recommended after replacing a control arm. Use the vehicle service information for the correct fasteners, torque values and whether any may be reused.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.